Magic Bullet Mb1001B Power Cord Replacement Repair Guide

Difficulty

Moderate

Steps

7

Time Required

                          8 - 15 minutes            

Sections

1

• Power Cord
• 7 steps

Flags

0

• BackMagic Bullet MB1001B

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Power Cord               

• Remove the four rubber pegs from the feet on the base of the Magic Bullet using the spudger.

Remove the four rubber pegs from the feet on the base of the Magic Bullet using the spudger.

1024

Step 2

• Remove the four 14.0 mm Phillips head screws in the feet of the base of the Magic Bullet using the Phillips #1 screwdriver.

Remove the four 14.0 mm Phillips head screws in the feet of the base of the Magic Bullet using the Phillips #1 screwdriver.

Step 3

• Remove the black base plate.

Remove the black base plate.

Step 4

• Remove the two 13.0 mm Phillips head screws from the white plastic cable guide using a Phillips #1 screwdriver.

Remove the two 13.0 mm Phillips head screws from the white plastic cable guide using a Phillips #1 screwdriver.

Step 5

• Remove the white plastic cable guide.

Remove the white plastic cable guide.

Step 6

• Remove the two crimp caps from the end of the wires.
• You will need to purchase new crimp caps and use pliers to crimp the new crimp caps on the connected wires during reassembly.

Remove the two crimp caps from the end of the wires.

You will need to purchase new crimp caps and use pliers to crimp the new crimp caps on the connected wires during reassembly.

Step 7

• Separate the black wires of the power cord from the red wires on the Magic Bullet base.
• Be sure to mark which wires are connected before separating them to ensure that they are properly reconnected during reassembly.

Separate the black wires of the power cord from the red wires on the Magic Bullet base.

Be sure to mark which wires are connected before separating them to ensure that they are properly reconnected during reassembly.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.                                             

Author

                                      with 5 other contributors 

                    Bridget Carr                     

Member since: 10/06/2015

266 Reputation

                                      1 Guide authored                  



                       Badges:
                       12







                                                        +9 more badges                           

Team

                       Cal Poly, Team 12-13, Maness Fall 2015                        

                                                  Member of Cal Poly, Team 12-13, Maness Fall 2015 



                    CPSU-MANESS-F15S12G13                     


                                            4 Members                     


                                            8 Guides authored                     

virginia.cooke - Jul 15, 2018

Reply

I accidentally burnt through my power cord. What type of power cord do I need to replace it?

davidcohnkettlebells - May 19, 2021

Reply

Where do we get a new power cord, and if that does not work, what do we do next?