Difficulty

Moderate

Steps

6

Time Required

                          10 - 15 minutes

Sections

2

  • Back Cover
  • 4 steps
  • Motherboard
  • 2 steps

Flags

3

Incorrect Tools

Help make this guide better by using the correct tools in images and/or text.

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackMagellan RoadMate 1200

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Cover
  • Remove the four rubber caps from the back by using the Phillips #00 screwdriver.

Remove the four rubber caps from the back by using the Phillips #00 screwdriver.

1024

Step 2

  • Remove the four screws holding the cover in place by using the Phillips #00 screwdriver.

Remove the four screws holding the cover in place by using the Phillips #00 screwdriver.

Step 3

  • Remove the back cover from the device by separating the back cover along its seam.
  • Slowly lift the cover—the speaker is screwed onto the back cover and is connected to the circuit board.

Remove the back cover from the device by separating the back cover along its seam.

Slowly lift the cover—the speaker is screwed onto the back cover and is connected to the circuit board.

Step 4

  • Pull the speaker cord, horizontally, by its base, away from the motherboard.
  • When reassembling, make sure that you plug the terminal in the same way. The black wire should be on the side farthest from the battery.

Pull the speaker cord, horizontally, by its base, away from the motherboard.

When reassembling, make sure that you plug the terminal in the same way. The black wire should be on the side farthest from the battery.

Step 5

              Motherboard
  • Remove the two screws on that are located on opposite sides of the board.

Remove the two screws on that are located on opposite sides of the board.

Step 6

  • Lift up the circuit board and disconnect the GPS wire, pulling horizontally from its connector port.

Lift up the circuit board and disconnect the GPS wire, pulling horizontally from its connector port.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 8 other contributors 


                    Ross Light

Member since: 04/12/2010

196 Reputation

                                      6 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges