Difficulty

Easy

Steps

5

Time Required

Suggest a time??

Sections

2

  • Back Cover
  • 4 steps
  • Battery
  • 1 step

Flags

Incorrect Tools

Help make this guide better by using the correct tools in images and/or text.

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackMagellan RoadMate 1200

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Cover
  • Remove the four rubber caps from the back by using the Phillips #00 screwdriver.

Remove the four rubber caps from the back by using the Phillips #00 screwdriver.

1024

Step 2

  • Remove the four screws holding the cover in place by using the Phillips #00 screwdriver.

Remove the four screws holding the cover in place by using the Phillips #00 screwdriver.

Step 3

  • Remove the back cover from the device by separating the back cover along its seam.
  • Slowly lift the cover—the speaker is screwed onto the back cover and is connected to the circuit board.

Remove the back cover from the device by separating the back cover along its seam.

Slowly lift the cover—the speaker is screwed onto the back cover and is connected to the circuit board.

Step 4

  • Pull the speaker cord, horizontally, by its base, away from the motherboard.
  • When reassembling, make sure that you plug the terminal in the same way. The black wire should be on the side farthest from the battery.

Pull the speaker cord, horizontally, by its base, away from the motherboard.

When reassembling, make sure that you plug the terminal in the same way. The black wire should be on the side farthest from the battery.

Step 5

              Battery
  • Disconnect the battery connector from the circuit board.
  • Pry the battery off the circuit board. The adhesive attaching it shouldn’t require any other tools.

Disconnect the battery connector from the circuit board.

Pry the battery off the circuit board. The adhesive attaching it shouldn’t require any other tools.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      4 other people completed this guide.

Author

                                      with 3 other contributors 


                    Ross Light

Member since: 04/12/2010

196 Reputation

                                      6 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges