Difficulty
Moderate
Steps
10
Time Required
15 minutes
Sections
5
- Rear and Side Case
- 4 steps
- RS-DP-LS Switch
- 1 step
- Circuit Board
- 2 steps
- Buttons
- 2 steps
- Front Case
- 1 step
Flags
0
BackMad Catz Street Fighter IV FightPad
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Rear and Side Case
- Use tweezers to completely remove the sticker from the rear of controller.
Use tweezers to completely remove the sticker from the rear of controller.
1024
Step 2
- Find the seven 8.3 mm Phillips screws on the rear of the controller and remove them.
Find the seven 8.3 mm Phillips screws on the rear of the controller and remove them.
Step 3
- Use a plastic opening tool to separate the rear and front casing by inserting it in-between the two cases.
- Use the plastic opening tool to pry the two cases apart.
Use a plastic opening tool to separate the rear and front casing by inserting it in-between the two cases.
Use the plastic opening tool to pry the two cases apart.
Step 4
- Remove the two rubber side grips.
Remove the two rubber side grips.
Step 5
RS-DP-LS Switch
- Locate RS-DP-LS switch.
- Pull upwards on the switch to remove it.
Locate RS-DP-LS switch.
Pull upwards on the switch to remove it.
Step 6
Circuit Board
- Locate the four 8.3 mm Phillips screws on the circuit board and remove them.
Locate the four 8.3 mm Phillips screws on the circuit board and remove them.
Step 7
- Hold the controller cable at the area just before it meets the controller and slowly lift upwards to slide it out of its plastic slot and remove the circuit board.
- Be careful with the wires connected to the circuit board itself as they are thin and delicate.
- When reassembling the controller, make sure that the bottom plastic piece is fully inserted into its slot before replacing the circuit board.
Hold the controller cable at the area just before it meets the controller and slowly lift upwards to slide it out of its plastic slot and remove the circuit board.
Be careful with the wires connected to the circuit board itself as they are thin and delicate.
When reassembling the controller, make sure that the bottom plastic piece is fully inserted into its slot before replacing the circuit board.
Step 8
Buttons
- Remove the six buttons one by one by gripping the back of each one and pushing on them from the front.
- Use tweezers to remove the rubber part of the directional pad before you try to remove the shoulder buttons.
- When reinserting the buttons make sure they are in the correct place and oriented correctly.
Remove the six buttons one by one by gripping the back of each one and pushing on them from the front.
Use tweezers to remove the rubber part of the directional pad before you try to remove the shoulder buttons.
When reinserting the buttons make sure they are in the correct place and oriented correctly.
Step 9
- Remove the left and right shoulder buttons by sliding them out of their respective slots.
Remove the left and right shoulder buttons by sliding them out of their respective slots.
Step 10
Front Case
- Pull the plastic piece out from the bottom of the controller.
Pull the plastic piece out from the bottom of the controller.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 5 other contributors
Eric
Member since: 09/26/2012
117 Reputation
3 Guides authored
Badges:
10
+7 more badges
Team
Cal Poly, Team 1-7, Propen Fall 2012
Member of Cal Poly, Team 1-7, Propen Fall 2012
CPSU-PROPEN-F12S1G7
4 Members
14 Guides authored
