Featured

Featured Guide

Difficulty

Easy

Steps

7

Time Required

                          5 - 10 minutes

Sections

3

  • Rear and Side Case
  • 4 steps
  • RS-DP-LS Switch
  • 1 step
  • Circuit Board
  • 2 steps

Flags

2

This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.

This guide has been found to be exceptionally cool by the iFixit staff.

  • BackMad Catz Street Fighter IV FightPad

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Rear and Side Case
  • Use tweezers to completely remove the sticker from the rear of controller.

Use tweezers to completely remove the sticker from the rear of controller.

1024

Step 2

  • Find the seven 8.3 mm Phillips screws on the rear of the controller and remove them.

Find the seven 8.3 mm Phillips screws on the rear of the controller and remove them.

Step 3

  • Use a plastic opening tool to separate the rear and front casing by inserting it in-between the two cases.
  • Use the plastic opening tool to pry the two cases apart.

Use a plastic opening tool to separate the rear and front casing by inserting it in-between the two cases.

Use the plastic opening tool to pry the two cases apart.

Step 4

  • Remove the two rubber side grips.

Remove the two rubber side grips.

Step 5

              RS-DP-LS Switch
  • Locate RS-DP-LS switch.
  • Pull upwards on the switch to remove it.

Locate RS-DP-LS switch.

Pull upwards on the switch to remove it.

Step 6

              Circuit Board
  • Locate the four 8.3 mm Phillips screws on the circuit board and remove them.

Locate the four 8.3 mm Phillips screws on the circuit board and remove them.

Step 7

  • Hold the controller cable at the area just before it meets the controller and slowly lift upwards to slide it out of its plastic slot and remove the circuit board.
  • Be careful with the wires connected to the circuit board itself as they are thin and delicate.
  • When reassembling the controller, make sure that the bottom plastic piece is fully inserted into its slot before replacing the circuit board.

Hold the controller cable at the area just before it meets the controller and slowly lift upwards to slide it out of its plastic slot and remove the circuit board.

Be careful with the wires connected to the circuit board itself as they are thin and delicate.

When reassembling the controller, make sure that the bottom plastic piece is fully inserted into its slot before replacing the circuit board.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 8 other contributors 


                    Jefferson Hsu

Member since: 09/18/2012

411 Reputation

                                      3 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Cal Poly, Team 1-7, Propen Fall 2012                        

                                                  Member of Cal Poly, Team 1-7, Propen Fall 2012 



                    CPSU-PROPEN-F12S1G7                     


                                            4 Members                     


                                            14 Guides authored