Difficulty
Easy
Steps
5
Time Required
15 minutes
Sections
2
- Outer Casing
- 3 steps
- Power Button
- 2 steps
Flags
0
BackMad Catz Rock Band 4 Wireless Fender
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Be sure to remove the batteries before beginning.
What you need
Step 1
Outer Casing
- Flip the guitar over so it is back side up. The battery compartment should be facing up.
- Use a size J1 head screwdriver to remove the ten 5 mm short screws.
- Use a J1 screwdriver to remove the four 5 mm long screws on the back of the device.
Flip the guitar over so it is back side up. The battery compartment should be facing up.
Use a size J1 head screwdriver to remove the ten 5 mm short screws.
Use a J1 screwdriver to remove the four 5 mm long screws on the back of the device.
1024
Step 2
- Turn the device over so the front of the guitar is facing you.
- Using a size J1 philips head screwdriver, remove the eleven 5 mm silver screws (circled in red) around the white panel.
Turn the device over so the front of the guitar is facing you.
Using a size J1 philips head screwdriver, remove the eleven 5 mm silver screws (circled in red) around the white panel.
Step 3
- Gently lift the white panel and twist 90 degrees clockwise.
- Using a size J1 head screwdriver, remove the two 5 mm black screws from underneath the white panel. You should now be able to pull the guitar apart.
Gently lift the white panel and twist 90 degrees clockwise.
Using a size J1 head screwdriver, remove the two 5 mm black screws from underneath the white panel. You should now be able to pull the guitar apart.
Step 4
Power Button
- Using a size J1 philips head screwdriver, remove the two black 5 mm screws (circled in red) from the back of the power button component. You can identify this by the code J5-B on the component.
Using a size J1 philips head screwdriver, remove the two black 5 mm screws (circled in red) from the back of the power button component. You can identify this by the code J5-B on the component.
Step 5
- Using your hands, lift the small, rectangular circuit board off and follow the connecting cords to the main circuit board.
- Unplug the cord connected to the battery component from the main circuit board.
Using your hands, lift the small, rectangular circuit board off and follow the connecting cords to the main circuit board.
Unplug the cord connected to the battery component from the main circuit board.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
3 other people completed this guide.
Author
with 3 other contributors
Catherine Lintner
Member since: 09/21/2016
581 Reputation
4 Guides authored
Badges:
15
+12 more badges
Team
USF Tampa, Team 1-1, Cagle Fall 2016
Member of USF Tampa, Team 1-1, Cagle Fall 2016
USFT-CAGLE-F16S1G1
4 Members
6 Guides authored
Robert Houser Jr - Jan 28, 2021
Reply
I need two Rock Band 4 Home Button/Bluetooth Replacement Parts, where to locate??
My name is Robert.
Thank you in regards to whom can assist