Difficulty

Moderate

Steps

12

Time Required

                          15 - 20 minutes            

Sections

4

  • Battery
  • 2 steps
  • Input/Output Door
  • 2 steps
  • Lower Case
  • 5 steps
  • Modem Card
  • 3 steps

Flags

0

  • BackMacintosh PowerBook 165c

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery               
  • Orient the computer so the battery is facing you.
  • Slide the gray plastic battery cover to the right.

Orient the computer so the battery is facing you.

Slide the gray plastic battery cover to the right.

1024

Step 2

  • Pull the battery toward yourself until it is fully detached.

Pull the battery toward yourself until it is fully detached.

Step 3

              Input/Output Door               
  • Orient the computer right side up with the rear facing you.
  • Open the Input/Output (I/O) door.

Orient the computer right side up with the rear facing you.

Open the Input/Output (I/O) door.

Step 4

  • Carefully bend the door into an arch until one of the pins releases from its slot.
  • Once one of the pins is free, remove the I/O door from the computer.

Carefully bend the door into an arch until one of the pins releases from its slot.

Once one of the pins is free, remove the I/O door from the computer.

Step 5

              Lower Case               
  • Orient the computer with the bottom facing up and rear facing you. You should be able to read the Macintosh label in this position.

Orient the computer with the bottom facing up and rear facing you. You should be able to read the Macintosh label in this position.

Step 6

  • Use a T8 torx screwdriver to remove the 6.8mm long screw above and to the right of the modem jack.
  • Twist counter clockwise to remove the screw.

Use a T8 torx screwdriver to remove the 6.8mm long screw above and to the right of the modem jack.

Twist counter clockwise to remove the screw.

Step 7

  • Use a T10 torx screwdriver to remove the four, 18mm long screws from the lower case.

Use a T10 torx screwdriver to remove the four, 18mm long screws from the lower case.

Step 8

  • Place your hands on the lower case, just above the I/O panel, and slowly lift the lower case a few inches above the main body of the computer.
  • Release the large, gray interconnect ribbon cable just behind the I/O panel.
  • Caution: Lower case cannot be fully removed until two plastic clips in the front corners are released. See the following step for details.

Place your hands on the lower case, just above the I/O panel, and slowly lift the lower case a few inches above the main body of the computer.

Release the large, gray interconnect ribbon cable just behind the I/O panel.

Caution: Lower case cannot be fully removed until two plastic clips in the front corners are released. See the following step for details.

Step 9

  • Place your thumb on the upper case, inside the empty battery slot, and your index finger near your thumb on the left side of the lower case.
  • Pinch your thumb and index finger towards each other to release the clip. Without releasing pressure on the pinch grip, use your index finger to push the lower case upwards.
  • Lift the lower case to remove it.

Place your thumb on the upper case, inside the empty battery slot, and your index finger near your thumb on the left side of the lower case.

Pinch your thumb and index finger towards each other to release the clip. Without releasing pressure on the pinch grip, use your index finger to push the lower case upwards.

Lift the lower case to remove it.

Step 10

              Modem Card               
  • Orient the computer so the ports are facing you.

Orient the computer so the ports are facing you.

Step 11

  • Locate the Modem Card on the lower case.
  • Use a T8 torx screwdriver to remove the two, 7.7mm long screws from the two corners.
  • The modem card is an optional component on the Macintosh 165c, and may not be included in all devices.

Locate the Modem Card on the lower case.

Use a T8 torx screwdriver to remove the two, 7.7mm long screws from the two corners.

The modem card is an optional component on the Macintosh 165c, and may not be included in all devices.

Step 12

  • Lift the modem card directly upward until it releases from the connector.
  • If the modem card is difficult to remove, gently jostle it back and forth as you lift up.

Lift the modem card directly upward until it releases from the connector.

If the modem card is difficult to remove, gently jostle it back and forth as you lift up.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 

                    John                     

Member since: 10/12/2011

88 Reputation

                                      4 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges                           

Team

                       Cal Poly, Team 6-3, Regan Fall 2011                        

                                                  Member of Cal Poly, Team 6-3, Regan Fall 2011 



                    CPSU-REGAN-F11S6G3                     


                                            4 Members                     


                                            12 Guides authored