Difficulty
Easy
Steps
2
Time Required
3 minutes
Sections
1
- Lower Case
- 2 steps
Flags
0
BackMacBook Pro 17" Unibody
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Lower Case
- Remove the following ten screws securing the lower case to the upper case:
- Three 13.5 mm Phillips screws.
- Seven 3 mm Phillips screws.
Remove the following ten screws securing the lower case to the upper case:
Three 13.5 mm Phillips screws.
Seven 3 mm Phillips screws.
1024
Step 2
- Wedge your fingers between the lower case and the vent, and lift upward to release the two clips holding the lower case to the upper case.
- During reassembly, carefully align the lower case and then press it firmly until both clips engage.
- Remove the lower case.
Wedge your fingers between the lower case and the vent, and lift upward to release the two clips holding the lower case to the upper case.
During reassembly, carefully align the lower case and then press it firmly until both clips engage.
Remove the lower case.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
19 other people completed this guide.
Author
with 7 other contributors
Andrew Bookholt
575,478 Reputation
618 Guides authored
Badges:
47
+44 more badges
retrotechpost - Jan 19, 2018
Reply
Is there a DIY on replacing the rubber feet?