Macbook Pro 13 Unibody Late 2011 Lower Case Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          5 minutes

Sections

Lower Case
2 steps

Flags

BackMacBook Pro 13" Unibody Late 2011
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Lower Case

Remove the following ten screws:
Three 14.4 mm Phillips #00 screws
Three 3.5 mm Phillips #00 screws
Four 3.5 mm shouldered Phillips #00 screws
When replacing the small screws, align them perpendicular to the slight curvature of the case (they don’t go straight down).

Remove the following ten screws:

Three 14.4 mm Phillips #00 screws

Three 3.5 mm Phillips #00 screws

Four 3.5 mm shouldered Phillips #00 screws

When replacing the small screws, align them perpendicular to the slight curvature of the case (they don’t go straight down).

1024

Step 2

Use your fingers to pry the lower case away from the body of the MacBook near the vent.
Remove the lower case.

Use your fingers to pry the lower case away from the body of the MacBook near the vent.

Remove the lower case.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      29 other people completed this guide.

Author

                                      with 4 other contributors

                    Phillip Takahashi

Member since: 08/22/2011

85,204 Reputation

                                      87 Guides authored                  



                       Badges:
                       43







                                                        +40 more badges

Introduction#

What you need#

#

#

#

#

Introduction

What you need