Macbook Pro 13 Unibody Early 2011 Lower Case Replacement Repair Guide

Difficulty

Easy

Steps

2

Time Required

                          1 - 5 minutes            

Sections

1

• Lower Case
• 2 steps

Flags

0

• BackMacBook Pro 13" Unibody Early 2011

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Lower Case               

• Remove the following ten screws:
• Three 14.4 mm Phillips #00 screws
• Three 3.5 mm Phillips #00 screws
• Four 3.5 mm shouldered Phillips #00 screws
• When replacing the small screws, align them perpendicular to the slight curvature of the case (they don’t go straight down).

Remove the following ten screws:

Three 14.4 mm Phillips #00 screws

Three 3.5 mm Phillips #00 screws

Four 3.5 mm shouldered Phillips #00 screws

When replacing the small screws, align them perpendicular to the slight curvature of the case (they don’t go straight down).

1024

Step 2

• Use your fingers to pry the lower case away from the body of the MacBook near the vent.
• Remove the lower case.

Use your fingers to pry the lower case away from the body of the MacBook near the vent.

Remove the lower case.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      59 other people completed this guide.                                             

Author

                                      with 11 other contributors 

                    Andrew Bookholt                     

575,478 Reputation

                                      618 Guides authored                  



                       Badges:
                       47







                                                        +44 more badges