Difficulty
Moderate
Steps
8
Time Required
15 - 30 minutes
Sections
3
- Lower Case
- 3 steps
- Battery Connector
- 3 steps
- SSD
- 2 steps
Flags
0
BackMacBook Pro 13" Retina Display Mid 2014
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Before you perform this repair, if at all possible, back up your existing SSD. Then, either familiarize yourself with internet recovery or create a bootable external drive so you’ll be ready to install macOS onto your new drive and migrate your data to the new SSD.
Finally, we strongly recommend installing macOS 10.13 High Sierra (or a later macOS) before replacing the original SSD from your MacBook Pro. Most new SSDs require updated storage drivers not found in versions of macOS prior to High Sierra.
What you need
Step 1
Lower Case
- Remove the following ten screws securing the lower case to the upper case:
- Two 2.3 mm P5 Pentalobe screws
- Eight 3.0 mm P5 Pentalobe screws
- Throughout this repair, keep track of each screw and make sure it goes back exactly where it came from to avoid damaging your device.
Remove the following ten screws securing the lower case to the upper case:
Two 2.3 mm P5 Pentalobe screws
Eight 3.0 mm P5 Pentalobe screws
Throughout this repair, keep track of each screw and make sure it goes back exactly where it came from to avoid damaging your device.
1024
Step 2
- Wedge your fingers between the upper case and the lower case.
- Gently pull the lower case away from the upper case to remove it.
Wedge your fingers between the upper case and the lower case.
Gently pull the lower case away from the upper case to remove it.
Step 3
- The lower case is connected to the upper case with two plastic clips near its center.
- During reassembly, gently push down the center of the lower case to reattach the two plastic clips.
The lower case is connected to the upper case with two plastic clips near its center.
During reassembly, gently push down the center of the lower case to reattach the two plastic clips.
Step 4
Battery Connector
- If necessary, remove the plastic cover adhered to the battery contact board.
If necessary, remove the plastic cover adhered to the battery contact board.
Step 5
- Use the flat end of a spudger to lift the battery connector straight up out of its socket on the logic board.
- Be sure you lift up only on the connector itself, not the socket, or you risk permanent damage to the logic board.
Use the flat end of a spudger to lift the battery connector straight up out of its socket on the logic board.
Be sure you lift up only on the connector itself, not the socket, or you risk permanent damage to the logic board.
Step 6
- Bend the battery connector up out of the way to prevent accidental contact with its socket during your repair.
Bend the battery connector up out of the way to prevent accidental contact with its socket during your repair.
Step 7
SSD
- Remove the single 2.9 mm T5 Torx screw securing the SSD to the logic board.
Remove the single 2.9 mm T5 Torx screw securing the SSD to the logic board.
Step 8
- Lift the free end of the SSD up slightly and pull the SSD straight out of its socket on the logic board.
- Only lift the end of the SSD enough to allow you to pull it out—about 1/4".
Lift the free end of the SSD up slightly and pull the SSD straight out of its socket on the logic board.
Only lift the end of the SSD enough to allow you to pull it out—about 1/4".
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
159 other people completed this guide.
Author
with 5 other contributors
Sam Goldheart
Member since: 10/18/2012
455,549 Reputation
548 Guides authored
Badges:
48
+45 more badges
Team
iFixit
Member of iFixit
Community
141 Members
15,767 Guides authored
Pieter Baeyens - Sep 25, 2014
Reply
Hello
Can you confirm that the ssd for the macbook pro mid 2014 really is replaceable?
I hear rumours that the ssd is stuck to the motherbord.
Syafiq Sufi - Jun 3, 2015
I changed the MacBook Pro 13’ Mid 2014 SSD successfully from 120GB to 1000GB. Follow all the steps provided and everything will be fine.
Joe Wilkie - Sep 28, 2016
I spoke with an apple expert at the genius bar and they said that the SSD is Soldered into the motherboard itself. Which is why I bought another MacBook pro for $1500 after mine had corrupted. Once I was informed you could change it out, I filed a complaint with Apple’s Tech Support, which they did nothing about and said that their employees were uninformed.
Pasi Kivikangas - Dec 13, 2018
Yes, I just replaced my MBP Mid 2014 128GB SSD with 480GB SSD. So, I can confirm it works.
Robert Kelly - Oct 24, 2014
Reply
Why is it necessary to disconnect the battery for the SSD replacement?