Difficulty

Moderate

Steps

7

Time Required

Suggest a time??

Sections

3

  • Lower Case
  • 2 steps
  • Battery
  • 3 steps
  • Logic Board Bracket
  • 2 steps

Flags

0

  • BackMacBook Air Models A1237 and A1304

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Lower Case
  • Unplug your MacBook Air and power it off before you proceed.
  • Remove ten Phillips screws securing the lower case to the MacBook Air:
  • Six 2.8 mm screws
  • Two 3.8 mm screws
  • Two 5.4 mm screws

Unplug your MacBook Air and power it off before you proceed.

Remove ten Phillips screws securing the lower case to the MacBook Air:

Six 2.8 mm screws

Two 3.8 mm screws

Two 5.4 mm screws

1024

Step 2

  • Slightly lift the lower case near the vents and push it toward the rear of the computer to free the mounting tabs.

Slightly lift the lower case near the vents and push it toward the rear of the computer to free the mounting tabs.

Step 3

              Battery
  • Disconnect the battery connector by pulling it straight out of its socket.

Disconnect the battery connector by pulling it straight out of its socket.

Step 4

  • Remove the following nine screws securing the battery to the Air:
  • Four 2.9 mm Phillips.
  • Four 3.8 mm Phillips.
  • One 7.2 mm Phillips.

Remove the following nine screws securing the battery to the Air:

Four 2.9 mm Phillips.

Four 3.8 mm Phillips.

One 7.2 mm Phillips.

Step 5

  • Lift the battery out of the Air.
  • If you’re installing a new battery, you should calibrate it after installation:
  • Charge it to 100%, and then keep charging it for at least 2 more hours. Then, unplug and use it normally to drain the battery. When you see the low battery warning, save your work, and keep your laptop on until it goes to sleep due to low battery. Wait at least 5 hours, then charge your laptop uninterrupted to 100%.
  • If you notice any unusual behavior or problems after installing your new battery, you may need to reset your MacBook’s SMC.

Lift the battery out of the Air.

If you’re installing a new battery, you should calibrate it after installation:

Charge it to 100%, and then keep charging it for at least 2 more hours. Then, unplug and use it normally to drain the battery. When you see the low battery warning, save your work, and keep your laptop on until it goes to sleep due to low battery. Wait at least 5 hours, then charge your laptop uninterrupted to 100%.

If you notice any unusual behavior or problems after installing your new battery, you may need to reset your MacBook’s SMC.

Step 6

              Logic Board Bracket
  • Remove the two small Phillips screws securing the logic board bracket to the upper case.

Remove the two small Phillips screws securing the logic board bracket to the upper case.

Step 7

  • Lift the logic board bracket out of the upper case.

Lift the logic board bracket out of the upper case.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      4 other people completed this guide.

Author

                                      with 2 other contributors 


                    Walter Galan

682,038 Reputation

                                      1,203 Guides authored                  



                       Badges:
                       54







                                                        +51 more badges