Macbook Air 13 Retina Display 2019 Lower Case Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          2 - 5 minutes

Sections

Lower Case
2 steps

Flags

BackMacBook Air 13" Retina 2019
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Remove the screws securing the lower case

Before starting this procedure, you should disable your Mac’s Auto Boot feature. Auto Boot powers on your Mac when you open the lid, and may be accidentally triggered during disassembly. Use this guide to disable Auto Boot.
If your MacBook is running Big Sur v11.1 or later, disabling Auto Boot may not work. You can proceed normally, but make sure to disconnect the battery as soon as you’re inside.
Completely power off and unplug your MacBook Air before you start. Close the display and flip the entire laptop upside-down.
Use a P5 driver to remove the following screws:
Two 7.9 mm screws
Two 7.1 mm screws
Six 2.6 mm screws

Before starting this procedure, you should disable your Mac’s Auto Boot feature. Auto Boot powers on your Mac when you open the lid, and may be accidentally triggered during disassembly. Use this guide to disable Auto Boot.

If your MacBook is running Big Sur v11.1 or later, disabling Auto Boot may not work. You can proceed normally, but make sure to disconnect the battery as soon as you’re inside.

Completely power off and unplug your MacBook Air before you start. Close the display and flip the entire laptop upside-down.

Use a P5 driver to remove the following screws:

Two 7.9 mm screws

Two 7.1 mm screws

Six 2.6 mm screws

1024

Step 2

              Remove the lower case

Wedge your fingers between the display and the lower case and pull upward to pop the lower case off the Air.
Remove the lower case.

Wedge your fingers between the display and the lower case and pull upward to pop the lower case off the Air.

Remove the lower case.

Compare your new replacement part to the original part—you may need to transfer remaining components or remove adhesive backings from the new part before installing.

To reassemble your device, follow the above steps in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Check out our Answers community for troubleshooting help.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors

                    Adam O'Camb

Member since: 04/11/2015

173,479 Reputation

                                      418 Guides authored                  



                       Badges:
                       39







                                                        +36 more badges

Introduction#

What you need#

#

#

#

#

Introduction

What you need