Difficulty
Moderate
Steps
5
Time Required
Suggest a time??
Sections
3
- Lower Case
- 2 steps
- Battery
- 1 step
- I/O Board Cable
- 2 steps
Flags
0
BackMacBook Air 11" Mid 2012
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Lower Case
- Shut down and close your computer. Lay it on a soft surface top-side down.
- Remove the following ten screws:
- Two 8 mm 5-point Pentalobe screws
- Eight 2.5 mm 5-point Pentalobe screws
- The special screwdriver needed to remove the 5-point Pentalobe screws can be found here.
Shut down and close your computer. Lay it on a soft surface top-side down.
Remove the following ten screws:
Two 8 mm 5-point Pentalobe screws
Eight 2.5 mm 5-point Pentalobe screws
The special screwdriver needed to remove the 5-point Pentalobe screws can be found here.
1024
Step 2
- Wedge your fingers between the display and the lower case and pull upward to pop the lower case off the Air.
Wedge your fingers between the display and the lower case and pull upward to pop the lower case off the Air.
Step 3
Battery
- In this step you will disconnect the battery to help avoid shorting out any components during service.
- Use the flat end of a spudger to pry both short sides of the battery connector upward to disconnect it from its socket on the logic board.
- Bend the battery cable slightly away from the logic board so the connector will not accidentally contact its socket.
In this step you will disconnect the battery to help avoid shorting out any components during service.
Use the flat end of a spudger to pry both short sides of the battery connector upward to disconnect it from its socket on the logic board.
Bend the battery cable slightly away from the logic board so the connector will not accidentally contact its socket.
Step 4
I/O Board Cable
- Use the flat end of a spudger to pry the I/O board cable connector upward out of its socket on the I/O board.
Use the flat end of a spudger to pry the I/O board cable connector upward out of its socket on the I/O board.
Step 5
- The following connector has an especially deep socket. Use care when disconnecting it.
- While gently pulling the I/O board cable upward near its connection to the logic board, use the tip of a spudger to pry upward on alternating sides of the connector to help “walk” it out of its socket.
- Remove the I/O board cable.
The following connector has an especially deep socket. Use care when disconnecting it.
While gently pulling the I/O board cable upward near its connection to the logic board, use the tip of a spudger to pry upward on alternating sides of the connector to help “walk” it out of its socket.
Remove the I/O board cable.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
3 other people completed this guide.
Author
with 2 other contributors
Andrew Optimus Goldheart
Member since: 10/17/2009
491,689 Reputation
411 Guides authored
Badges:
44
+41 more badges
Team
iFixit
Member of iFixit
Community
141 Members
15,767 Guides authored
Steven Pierce - Feb 13, 2022
Reply
You only show the basic part of the removal. You do not show how to actually remove that board. You should have shown more steps.