Difficulty
Moderate
Steps
6
Time Required
Suggest a time??
Sections
3
- Lower Case
- 2 steps
- Battery
- 1 step
- AirPort/Bluetooth Card
- 3 steps
Flags
0
BackMacBook Air 11" Mid 2012
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Lower Case
- Shut down and close your computer. Lay it on a soft surface top-side down.
- Remove the following ten screws:
- Two 8 mm 5-point Pentalobe screws
- Eight 2.5 mm 5-point Pentalobe screws
- The special screwdriver needed to remove the 5-point Pentalobe screws can be found here.
Shut down and close your computer. Lay it on a soft surface top-side down.
Remove the following ten screws:
Two 8 mm 5-point Pentalobe screws
Eight 2.5 mm 5-point Pentalobe screws
The special screwdriver needed to remove the 5-point Pentalobe screws can be found here.
1024
Step 2
- Wedge your fingers between the display and the lower case and pull upward to pop the lower case off the Air.
Wedge your fingers between the display and the lower case and pull upward to pop the lower case off the Air.
Step 3
Battery
- In this step you will disconnect the battery to help avoid shorting out any components during service.
- Use the flat end of a spudger to pry both short sides of the battery connector upward to disconnect it from its socket on the logic board.
- Bend the battery cable slightly away from the logic board so the connector will not accidentally contact its socket.
In this step you will disconnect the battery to help avoid shorting out any components during service.
Use the flat end of a spudger to pry both short sides of the battery connector upward to disconnect it from its socket on the logic board.
Bend the battery cable slightly away from the logic board so the connector will not accidentally contact its socket.
Step 4
AirPort/Bluetooth Card
- Use the flat end of a spudger to pry both antenna connectors up from their sockets on the AirPort/Bluetooth card.
Use the flat end of a spudger to pry both antenna connectors up from their sockets on the AirPort/Bluetooth card.
Step 5
- Remove the single 2.9 mm T5 Torx screw securing the AirPort/Bluetooth card to the logic board.
Remove the single 2.9 mm T5 Torx screw securing the AirPort/Bluetooth card to the logic board.
Step 6
- Slightly lift the free end of the AirPort/Bluetooth board and pull it out of its socket on the logic board.
- To avoid damaging its socket on the logic board, do not excessively lift the free end of the AirPort/Bluetooth card.
- Remove the AirPort/Bluetooth board from the Air.
Slightly lift the free end of the AirPort/Bluetooth board and pull it out of its socket on the logic board.
To avoid damaging its socket on the logic board, do not excessively lift the free end of the AirPort/Bluetooth card.
Remove the AirPort/Bluetooth board from the Air.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
11 other people completed this guide.
Author
with 1 other contributor
Andrew Optimus Goldheart
Member since: 10/17/2009
491,689 Reputation
411 Guides authored
Badges:
44
+41 more badges
Team
iFixit
Member of iFixit
Community
141 Members
15,767 Guides authored
Todd - Mar 16, 2018
Reply
Is that a mini pcie cable that is used for the networking card? I just am wondering if it is possible to disconnect the airport card and install a egpu there