Difficulty

Moderate

Steps

5

Time Required

                          10 minutes

Sections

3

  • Lower Case
  • 2 steps
  • Battery
  • 1 step
  • I/O Board Cable
  • 2 steps

Flags

0

  • BackMacBook Air 11" Mid 2011

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Lower Case
  • Shut down and close your computer. Lay it on a soft surface top-side down.
  • Remove the following ten screws:
  • Two 8 mm 5-point Pentalobe screws
  • Eight 2.5 mm 5-point Pentalobe screws
  • The special screwdriver needed to remove the 5-point Pentalobe screws can be found here.

Shut down and close your computer. Lay it on a soft surface top-side down.

Remove the following ten screws:

Two 8 mm 5-point Pentalobe screws

Eight 2.5 mm 5-point Pentalobe screws

The special screwdriver needed to remove the 5-point Pentalobe screws can be found here.

1024

Step 2

  • Wedge your fingers between the display and the lower case and pull upward to pop the lower case off the Air.

Wedge your fingers between the display and the lower case and pull upward to pop the lower case off the Air.

Step 3

              Battery
  • In this step you will disconnect the battery to help avoid shorting out any components during service.
  • Use the flat end of a spudger to pry both short sides of the battery connector upward to disconnect it from its socket on the logic board.
  • Bend the battery cable slightly away from the logic board so the connector will not accidentally contact its socket.

In this step you will disconnect the battery to help avoid shorting out any components during service.

Use the flat end of a spudger to pry both short sides of the battery connector upward to disconnect it from its socket on the logic board.

Bend the battery cable slightly away from the logic board so the connector will not accidentally contact its socket.

Step 4

              I/O Board Cable
  • Use the flat end of a spudger to pry the I/O board cable connector upward out of its socket on the I/O board.

Use the flat end of a spudger to pry the I/O board cable connector upward out of its socket on the I/O board.

Step 5

  • The following connector has an especially deep socket. Use care when disconnecting it.
  • While gently pulling the I/O board cable upward near its connection to the logic board, use the tip of a spudger to pry upward on alternating sides of the connector to help “walk” it out of its socket.
  • Remove the I/O board cable.

The following connector has an especially deep socket. Use care when disconnecting it.

While gently pulling the I/O board cable upward near its connection to the logic board, use the tip of a spudger to pry upward on alternating sides of the connector to help “walk” it out of its socket.

Remove the I/O board cable.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 4 other contributors 


                    Walter Galan

682,038 Reputation

                                      1,203 Guides authored                  



                       Badges:
                       54







                                                        +51 more badges

Jean Wallemacq - Dec 20, 2020

Reply

I had no sound (input/output), no video, no ability to work on battery. I followed the steps and discovered that both the battery and the i/o board where not properly connected. So following this manual fixed it all. Many thanks!