Difficulty

Moderate

Steps

7

Time Required

Suggest a time??

Sections

3

  • Bottom Cover
  • 2 steps
  • Fan
  • 3 steps
  • Cowling
  • 2 steps

Flags

0

  • BackMac mini Mid 2011

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Bottom Cover
  • Place your thumbs in the depressions cut into the bottom cover.
  • Rotate the bottom cover counter-clockwise until the white dot painted on the bottom cover is aligned with the ring inscribed on the outer case.
  • You do not need to apply much downward pressure while turning.

Place your thumbs in the depressions cut into the bottom cover.

Rotate the bottom cover counter-clockwise until the white dot painted on the bottom cover is aligned with the ring inscribed on the outer case.

You do not need to apply much downward pressure while turning.

1024

Step 2

  • Tilt the mini enough to allow the bottom cover to fall away from the outer case.
  • Remove the bottom cover and set it aside.

Tilt the mini enough to allow the bottom cover to fall away from the outer case.

Remove the bottom cover and set it aside.

Step 3

              Fan
  • Remove the two 11.3 mm T6 Torx screws securing the fan to the logic board near the antenna plate.

Remove the two 11.3 mm T6 Torx screws securing the fan to the logic board near the antenna plate.

Step 4

  • Lift the ear of the fan nearest the RAM up off the standoff secured to the outer case.
  • Removing the standoff screw is not necessary to remove the fan. You need only raise the fan enough to lift it off the standoff screw.

Lift the ear of the fan nearest the RAM up off the standoff secured to the outer case.

Removing the standoff screw is not necessary to remove the fan. You need only raise the fan enough to lift it off the standoff screw.

Step 5

  • Lift the fan out of the mini for enough clearance to access its connector.
  • Grab all the wires at once and gently pull straight up to disconnect the fan from the logic board.
  • Do not pry at the socket, or you may rip it from the logic board.
  • Remove the fan.

Lift the fan out of the mini for enough clearance to access its connector.

Grab all the wires at once and gently pull straight up to disconnect the fan from the logic board.

Do not pry at the socket, or you may rip it from the logic board.

Remove the fan.

Step 6

              Cowling
  • Remove the single 3.5 mm T6 Torx screw securing the cowling to the heat sink.

Remove the single 3.5 mm T6 Torx screw securing the cowling to the heat sink.

Step 7

  • Lift the cowling from the end nearest the antenna plate.
  • Rotate the cowling away from the outer case and remove it from the mini.

Lift the cowling from the end nearest the antenna plate.

Rotate the cowling away from the outer case and remove it from the mini.

Cancel: I did not complete this guide.

                                                                                      9 other people completed this guide.

Author

                                      with 3 other contributors 


                    Walter Galan

682,038 Reputation

                                      1,203 Guides authored                  



                       Badges:
                       54







                                                        +51 more badges