Difficulty

Moderate

Steps

7

Time Required

Suggest a time??

Sections

3

  • Bottom Cover
  • 2 steps
  • Fan
  • 3 steps
  • Cowling
  • 2 steps

Flags

0

  • BackMac mini Mid 2010

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Bottom Cover
  • Place your thumbs in the depressions cut into the bottom cover.
  • Rotate the bottom cover counter-clockwise until the white dot painted on the bottom cover is aligned with the ring inscribed on the outer case.

Place your thumbs in the depressions cut into the bottom cover.

Rotate the bottom cover counter-clockwise until the white dot painted on the bottom cover is aligned with the ring inscribed on the outer case.

1024

Step 2

  • Tilt the mini enough to allow the bottom cover to fall away from the outer case.
  • Remove the bottom cover and set it aside.

Tilt the mini enough to allow the bottom cover to fall away from the outer case.

Remove the bottom cover and set it aside.

Step 3

              Fan
  • Remove the two 11.3 mm T6 Torx screws securing the fan to the logic board near the antenna plate.

Remove the two 11.3 mm T6 Torx screws securing the fan to the logic board near the antenna plate.

Step 4

  • Lift the ear of the fan nearest the RAM up off the standoff secured to the outer case.
  • If the fan doesn’t separate from the standoff screw with a moderate amount of force, you can use a T6 Torx driver to simply remove this screw.

Lift the ear of the fan nearest the RAM up off the standoff secured to the outer case.

If the fan doesn’t separate from the standoff screw with a moderate amount of force, you can use a T6 Torx driver to simply remove this screw.

Step 5

  • Lift the fan out of the mini for enough clearance to access its connector.
  • Carefully pull the fan cables upward to lift the fan connector up out of its socket on the logic board.
  • Remove the fan.

Lift the fan out of the mini for enough clearance to access its connector.

Carefully pull the fan cables upward to lift the fan connector up out of its socket on the logic board.

Remove the fan.

Step 6

              Cowling
  • Remove the single 3.5 mm T6 Torx screw securing the cowling to the heat sink.

Remove the single 3.5 mm T6 Torx screw securing the cowling to the heat sink.

Step 7

  • Lift the cowling from the end nearest the antenna plate.
  • Rotate the cowling away from the outer case and remove it from the mini.

Lift the cowling from the end nearest the antenna plate.

Rotate the cowling away from the outer case and remove it from the mini.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      5 other people completed this guide.

Author

                                      with 3 other contributors 


                    Andrew Bookholt

575,478 Reputation

                                      618 Guides authored                  



                       Badges:
                       47







                                                        +44 more badges