M3D Micro Z Axis Belt Replacement Repair Guide

Difficulty

Easy

Steps

4

Time Required

                          15 minutes            

Sections

2

• M3D Micro Frame Removal
• 3 steps
• Z Axis Belt
• 1 step

Flags

0

• BackM3D Micro

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

Step 1

              M3D Micro Frame Removal               

• Removing the frame is necessary to access the z axis belt, motors and ports. Make sure the unit is unplugged and set on a hard level surface.

Removing the frame is necessary to access the z axis belt, motors and ports. Make sure the unit is unplugged and set on a hard level surface.

1024

Step 2

• Pull the x-rods away from the plastic sliders on the y-rods, and flip the slider upwards to release the tracks. Lift the extruder assembly out of the way.

Pull the x-rods away from the plastic sliders on the y-rods, and flip the slider upwards to release the tracks. Lift the extruder assembly out of the way.

Step 3

• No tools are required to remove the frame. Press down on the printing bed with your thumbs while lifting the frame with your fingers. The frame easily slides up.

No tools are required to remove the frame. Press down on the printing bed with your thumbs while lifting the frame with your fingers. The frame easily slides up.

Step 4

              Z Axis Belt               

• Remove the z axis belt from the device by simply lifting each corner of the belt off the corner gears and slide up over the z axis bars.

Remove the z axis belt from the device by simply lifting each corner of the belt off the corner gears and slide up over the z axis bars.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Danyel Browning                     

Member since: 09/28/2017

255 Reputation

                                      2 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges                           

Team

                       USF Tampa, Team S3-G2, Nance Fall 2017                        

                                                  Member of USF Tampa, Team S3-G2, Nance Fall 2017 



                    USFT-NANCE-F17S3G2                     


                                            4 Members                     


                                            10 Guides authored                     

Ramon Arguello - Nov 9, 2022

Reply

Need a replacement z axis belt for my M3D micro printer don’t know where to go to get one