Lorex Mc6950 Camera Lens Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          5 minutes

Sections

Camera Lens
5 steps

Flags

BackLorex MC6950
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Camera Lens

To remove a bad lens, you must begin by removing the three screw caps and the 15mm JIS 0 screws associated with them located on the plastic containment shell that the camera is in.

To remove a bad lens, you must begin by removing the three screw caps and the 15mm JIS 0 screws associated with them located on the plastic containment shell that the camera is in.

1024

Step 2

Next, the camera must be removed. A metal spudger will be useful to pry this out as it is sealed inside the outer containment shell.
Once the camera is removed, remove the wires from the outer containment shell.
Be careful. The metal spudger could damage the camera if not handled with care.

Next, the camera must be removed. A metal spudger will be useful to pry this out as it is sealed inside the outer containment shell.

Once the camera is removed, remove the wires from the outer containment shell.

Be careful. The metal spudger could damage the camera if not handled with care.

Step 3

With the camera in hand, the circuit board must be separated from the LED containment shell. There is a 5mm JIS 0 screw at every corner of the circuit board.
The wires attaching the circuit board to the shell should be removed as well.

With the camera in hand, the circuit board must be separated from the LED containment shell. There is a 5mm JIS 0 screw at every corner of the circuit board.

The wires attaching the circuit board to the shell should be removed as well.

Step 4

Now the motor housing must be removed from the circuit board first as it is in the way of the screws associated with the lens. There are three 5mm JIS 0 screws located on the lens side of the circuit board to remove the motor.

Now the motor housing must be removed from the circuit board first as it is in the way of the screws associated with the lens. There are three 5mm JIS 0 screws located on the lens side of the circuit board to remove the motor.

Step 5

The lens has two 5 mm JIS 0 screws located under the motor’s previous location. Once these are removed, the lens can be replaced.

The lens has two 5 mm JIS 0 screws located under the motor’s previous location. Once these are removed, the lens can be replaced.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors

                    Elijah Conlin

Member since: 11/07/2017

379 Reputation

                                      3 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       IUPUI, Team S2-G2, Harley Fall 2017                        

                                                  Member of IUPUI, Team S2-G2, Harley Fall 2017 



                    IUPUI-HARLEY-F17S2G2                     


                                            3 Members                     


                                            3 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team