Difficulty
Moderate
Steps
8
Time Required
15 minutes
Sections
2
- Battery
- 4 steps
- Wi-Fi Antenna
- 4 steps
Flags
1
Needs More Images
A few more images would make this guide’s procedures crystal clear.
BackLorex LW2744
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Remove the 5.0mm screw using the Phillips #0 head screwdriver.
Remove the 5.0mm screw using the Phillips #0 head screwdriver.
1024
Step 2
- Insert metal spudger as shown in the picture. Move spudger along to the other side until both snaps come loose.
Insert metal spudger as shown in the picture. Move spudger along to the other side until both snaps come loose.
Step 3
- Picture shows the removed battery cover.
Picture shows the removed battery cover.
Step 4
- Slide the battery out by pulling on one of two plastics tabs.
Slide the battery out by pulling on one of two plastics tabs.
Step 5
Wi-Fi Antenna
- Remove the remaining five 6.0 mm Phillips #0 screws.
Remove the remaining five 6.0 mm Phillips #0 screws.
Step 6
- Use the spudger to remove the back cover. Insert the spudger between the back and front cover. Once inserted, you will need to move it around the perimeter to release the snaps holding it together.
Use the spudger to remove the back cover. Insert the spudger between the back and front cover. Once inserted, you will need to move it around the perimeter to release the snaps holding it together.
Step 7
- Once back cover is removed, the speaker wire will need to be removed. Use tweezers to remove wire.
Once back cover is removed, the speaker wire will need to be removed. Use tweezers to remove wire.
Step 8
- Begin by heating the exposed end of the grey lead with the tip of a soldering iron while simultaneously pulling the lead away from the connection, using tweezers to grasp the lead by the insulation.
- For more information on soldering, check out this repair guide: iFixit Soldering
Begin by heating the exposed end of the grey lead with the tip of a soldering iron while simultaneously pulling the lead away from the connection, using tweezers to grasp the lead by the insulation.
For more information on soldering, check out this repair guide: iFixit Soldering
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Yancey Crase
Member since: 03/26/2018
217 Reputation
2 Guides authored
Badges:
3
Team
IUPUI, Team S1-G4, Harley Spring 2018
Member of IUPUI, Team S1-G4, Harley Spring 2018
IUPUI-HARLEY-S18S1G4
7 Members
5 Guides authored