Difficulty
Easy
Steps
5
Time Required
5 - 10 minutes
Sections
1
- Night Vision IR LEDs
- 5 steps
Flags
0
BackLorex LW2742
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Night Vision IR LEDs
- Remove the six 10mm Torx T10 screws on the camera face.
Remove the six 10mm Torx T10 screws on the camera face.
1024
Step 2
- Remove the exterior lens cover.
Remove the exterior lens cover.
Step 3
- Remove the LED foam ring with tweezers.
- Be aware, the electronic components of the LED board may be compromised if you use your fingers instead of tweezers for this step.
Remove the LED foam ring with tweezers.
Be aware, the electronic components of the LED board may be compromised if you use your fingers instead of tweezers for this step.
Step 4
- Remove the two 5mm Phillips #1 screws.
- Remove the two 8mm Phillips #0 screws.
- When reassembling, tighten the top and bottom 5mm screws first, followed by the left and right 8mm screws.
Remove the two 5mm Phillips #1 screws.
Remove the two 8mm Phillips #0 screws.
When reassembling, tighten the top and bottom 5mm screws first, followed by the left and right 8mm screws.
Step 5
- Use tweezers to unclip the cables to the LED board
Use tweezers to unclip the cables to the LED board
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 5 other contributors
craig crisci
Member since: 09/26/2016
220 Reputation
1 Guide authored
Badges:
8
+5 more badges
Team
USF Tampa, Team 16-1, Eyestone Fall 2016
Member of USF Tampa, Team 16-1, Eyestone Fall 2016
USFT-EYESTONE-F16S16G1
4 Members
12 Guides authored
