Difficulty
Moderate
Steps
5
Time Required
Suggest a time??
Sections
1
- Lorex A-MPX IR Bullet Camera Disassembly
- 5 steps
Flags
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackLorex A-MPX IR Bullet Camera
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Quick look
- This little camera comes with the LHA4000 kit by Lorex.
- It has a 4K sensor with motion sensor and infrared lights
This little camera comes with the LHA4000 kit by Lorex.
It has a 4K sensor with motion sensor and infrared lights
1024
Step 2
Removing the lense
- Remove the 4 screws holding down the camera lens. They are standard Philipps #1
- Be careful not to pull the sensor as it is still attached to the signal cables.
Remove the 4 screws holding down the camera lens. They are standard Philipps #1
Be careful not to pull the sensor as it is still attached to the signal cables.
Step 3
Camera Sensor
- The system board is directly attached to the back of the lens.
- The connector is a simple 4 wires. This make it very easy to repair.
The system board is directly attached to the back of the lens.
The connector is a simple 4 wires. This make it very easy to repair.
Step 4
Outer casing
- There is a rubber grommet that keep moisture away from the inside of the board.
- There IS also this sillica pack inside the camera if moisture ever breach in.
- The base is fixed to the feet using a single Phillips #1 screw
- In order to separate the camera from the feet, you will need to undo the connector. The wires are thin so be careful.
There is a rubber grommet that keep moisture away from the inside of the board.
There IS also this sillica pack inside the camera if moisture ever breach in.
The base is fixed to the feet using a single Phillips #1 screw
In order to separate the camera from the feet, you will need to undo the connector. The wires are thin so be careful.
Step 5
Whole assembly
- Very simple design for a very simple device. The whole assembly is held by 6 screws. Making it very easy to re-assemble.
Very simple design for a very simple device. The whole assembly is held by 6 screws. Making it very easy to re-assemble.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Hans
Member since: 10/20/2014
1,878 Reputation
6 Guides authored
Badges:
18
+15 more badges
Team
Mero IT Services
Member of Mero IT Services
Business
1 Member
6 Guides authored
Mark Curry - Jun 22, 2021
Reply
Can you do disassembly video on Lorex C861MB camera ?
Can you do a disassembly video on Lorex C861MB camera ?
Michael Teeter - Jun 20, 2022
Reply
How much is this camera