Logitech Pure Fi Anywhere 2 Inner Speaker Cones Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          15 - 20 minutes

Sections

Inner Speaker Cones
4 steps

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

BackLogitech Pure-Fi Anywhere 2
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

What you need

Step 1

              Inner Speaker Cones

To remove the plastic cover. You want to use the plastic opener and starting with corners.
Then insert the metal spudger in the opening and slowly move the metal spudger along all sides of the cover.
Caution: Metal spudger can damage the internal components of the device such as the motherboard. Make sure to use it carefully in order to avoid any unnecessary damages.
Make sure the metal supdger is inserted deep enough as the cover is glued to the device.
Carefully remove the cover as it can be very fragile

To remove the plastic cover. You want to use the plastic opener and starting with corners.

Then insert the metal spudger in the opening and slowly move the metal spudger along all sides of the cover.

Caution: Metal spudger can damage the internal components of the device such as the motherboard. Make sure to use it carefully in order to avoid any unnecessary damages.

Make sure the metal supdger is inserted deep enough as the cover is glued to the device.

Carefully remove the cover as it can be very fragile

1024

Step 2

Remove eight 10.5 mm Phillips #1 screws from the cover.
Insert a metal spurger at the corner to help loosen the cover.
There is still glue sticking the front cover and the back cover together.
Starting with corners, lift up the cover slowly and carefully.
Do not pull too hard when removing the cover. There are wires connecting between the battery and the circuit board.

Remove eight 10.5 mm Phillips #1 screws from the cover.

Insert a metal spurger at the corner to help loosen the cover.

There is still glue sticking the front cover and the back cover together.

Starting with corners, lift up the cover slowly and carefully.

Do not pull too hard when removing the cover. There are wires connecting between the battery and the circuit board.

Step 3

Identity the speaker cover, and remove four 4.5 mm Phillips #1 screws.
Lift up the cone. It should be removed very easily by hand.

Identity the speaker cover, and remove four 4.5 mm Phillips #1 screws.

Lift up the cone. It should be removed very easily by hand.

Step 4

Remove four 5.2mm Phillips #1 screws that are securing the circuit board.
Unplug the connecting wire from the circuit board. Carefully lift up the circuit board.
Same as step 3, remove four 4.5 mm Phillips #1 screws from the speaker cone.

Remove four 5.2mm Phillips #1 screws that are securing the circuit board.

Unplug the connecting wire from the circuit board. Carefully lift up the circuit board.

Same as step 3, remove four 4.5 mm Phillips #1 screws from the speaker cone.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors

                    junyi yang

Member since: 07/11/2018

109 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       IUPUI, Team S4-G4, Wilson Summer 2018                        

                                                  Member of IUPUI, Team S4-G4, Wilson Summer 2018 



                    IUPUI-WILSON-SU18S4G4                     


                                            4 Members                     


                                            2 Guides authored

Better Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Better Introduction

What you need

Team