Difficulty
Moderate
Steps
5
Time Required
15 - 20 minutes
Sections
1
- Dock Adapter Cover
- 5 steps
Flags
Better Introduction
Improve this guide by completing or revising its introduction.
BackLogitech Pure-Fi Anywhere 2
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Dock Adapter Cover
- To remove the plastic cover, use the plastic opening tool at the corner of the device.
- Then insert the metal spudger in the opening and slowly move the metal spudger along all sides of the cover.
- Caution: Metal spudger can damage the internal components of the device such as the motherboard. Make sure to use the metal spudger carefully to avoid any unnecessary damages.
- Make sure the metal supdger is inserted deep enough as the cover is glued to the device.
- Caution: Carefully remove the cover as it is easy to break.
To remove the plastic cover, use the plastic opening tool at the corner of the device.
Then insert the metal spudger in the opening and slowly move the metal spudger along all sides of the cover.
Caution: Metal spudger can damage the internal components of the device such as the motherboard. Make sure to use the metal spudger carefully to avoid any unnecessary damages.
Make sure the metal supdger is inserted deep enough as the cover is glued to the device.
Caution: Carefully remove the cover as it is easy to break.
1024
Step 2
- Remove the eight 10.5 mm Phillips #1 screws securing the cover.
- Remove three 5.2 mm Philips #1 screws securing the dock.
Remove the eight 10.5 mm Phillips #1 screws securing the cover.
Remove three 5.2 mm Philips #1 screws securing the dock.
Step 3
- Use the metal spudger to loosen the front cover to get into the inner part of the device.
- Metal spudger can damage the internal components of the device such as the motherboard. Make sure to use the metal spudger carefully to avoid any unnecessary damages.
- Make sure to carefully lift up the front cover from the back cover.
- There are wires connecting to between battery and the cover.
Use the metal spudger to loosen the front cover to get into the inner part of the device.
Metal spudger can damage the internal components of the device such as the motherboard. Make sure to use the metal spudger carefully to avoid any unnecessary damages.
Make sure to carefully lift up the front cover from the back cover.
There are wires connecting to between battery and the cover.
Step 4
- Identify the small circuit board attached to the dock adapter cover.
- remove two 2.5 mm Phillips #1 screws at the circuit board.
Identify the small circuit board attached to the dock adapter cover.
remove two 2.5 mm Phillips #1 screws at the circuit board.
Step 5
- Carefully take out the dock adapter cover from the device.
- It might needs few try to pull out the small circuit board.
- Take out the broken dock adapter cover and replace with the new one.
Carefully take out the dock adapter cover from the device.
It might needs few try to pull out the small circuit board.
Take out the broken dock adapter cover and replace with the new one.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
ali alhashim
Member since: 07/18/2018
121 Reputation
1 Guide authored
Badges:
2
Team
IUPUI, Team S4-G4, Wilson Summer 2018
Member of IUPUI, Team S4-G4, Wilson Summer 2018
IUPUI-WILSON-SU18S4G4
4 Members
2 Guides authored
