Difficulty

Easy

Steps

10

Time Required

                          1 - 2 minutes

Sections

2

  • Logitech K120 Keyboard Disassembly
  • 8 steps
  • USB Cable
  • 2 steps

Flags

1

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackLogitech K120 Keyboard

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Removing Screws
  • Remove the Phillips #000 screw. Turn the screwdriver counter-clockwise.

Remove the Phillips #000 screw. Turn the screwdriver counter-clockwise.

1024

Step 2

              Separating The Keyboard's Chassis
  • Use the spudger to separate the top of keyboard from the bottom of the keyboard.

Use the spudger to separate the top of keyboard from the bottom of the keyboard.

Step 3

              Removing The Top Of The Keyboard
  • Remove the top of the keyboard and put it aside.

Remove the top of the keyboard and put it aside.

Step 4

              Removing The Bracket
  • Unscrew the highlighted screws using a Phillips #000 Screwdriver. Turn the screwdriver counter-clockwise.

Unscrew the highlighted screws using a Phillips #000 Screwdriver. Turn the screwdriver counter-clockwise.

Step 5

              Removing The Circuit Board
  • Use the spudger and carefully pry the connector out of its socket. (Highlighted in the pictures)

Use the spudger and carefully pry the connector out of its socket. (Highlighted in the pictures)

Step 6

              Removing The Cable
  • Carefully nudge the connector out of the hole in which the cable enters the keyboard’s chassis.

Carefully nudge the connector out of the hole in which the cable enters the keyboard’s chassis.

Step 7

              Removing The Membrane
  • Peel the membrane off carefully so that the membrane doesn’t rip.

Peel the membrane off carefully so that the membrane doesn’t rip.

Step 8

              Remove The 2nd Membrane
  • Stick the sharp end of the spudger into the corner of the second membrane and bring the spudger partly underneath the membrane.
  • Lift the membrane off of the first standoff.
  • Peel the rest of the membrane off carefully so the membrane doesn’t rip.

Stick the sharp end of the spudger into the corner of the second membrane and bring the spudger partly underneath the membrane.

Lift the membrane off of the first standoff.

Peel the rest of the membrane off carefully so the membrane doesn’t rip.

Step 9

              Install The New Cable
  • Slide the new cable into the hole.

Slide the new cable into the hole.

Step 10

              Connect The New Cable
  • Connect The Cable To The Circuit Board.

Connect The Cable To The Circuit Board.

To reassemble your device, follow the instructions on how to reassemble your device in the prerequisite guide.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Marcus Jones

Member since: 11/22/2018

1,115 Reputation

                                      6 Guides authored                  



                       Badges:
                       19







                                                        +16 more badges

Robin Lane - Jun 23, 2021

Reply

Hi there,

Nice guide! Where do I get hold of a replacement USB wire / what’s the specific name of it?

Thanks,

Robin