Difficulty
Easy
Steps
8
Time Required
10 - 20 minutes
Sections
1
- Logitech K120 Keyboard Disassembly
- 8 steps
Flags
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackLogitech K120 Keyboard
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Video Overview
Step 1
Removing Screws
- Remove the Phillips #000 screw. Turn the screwdriver counter-clockwise.
Remove the Phillips #000 screw. Turn the screwdriver counter-clockwise.
1024
Step 2
Separating The Keyboard's Chassis
- Use the spudger to separate the top of keyboard from the bottom of the keyboard.
Use the spudger to separate the top of keyboard from the bottom of the keyboard.
Step 3
Removing The Top Of The Keyboard
- Remove the top of the keyboard and put it aside.
Remove the top of the keyboard and put it aside.
Step 4
Removing The Bracket
- Unscrew the highlighted screws using a Phillips #000 Screwdriver. Turn the screwdriver counter-clockwise.
Unscrew the highlighted screws using a Phillips #000 Screwdriver. Turn the screwdriver counter-clockwise.
Step 5
Removing The Circuit Board
- Use the spudger and carefully pry the connector out of its socket. (Highlighted in the pictures)
Use the spudger and carefully pry the connector out of its socket. (Highlighted in the pictures)
Step 6
Removing The Cable
- Carefully nudge the connector out of the hole in which the cable enters the keyboard’s chassis.
Carefully nudge the connector out of the hole in which the cable enters the keyboard’s chassis.
Step 7
Removing The Membrane
- Peel the membrane off carefully so that the membrane doesn’t rip.
Peel the membrane off carefully so that the membrane doesn’t rip.
Step 8
Remove The 2nd Membrane
- Stick the sharp end of the spudger into the corner of the second membrane and bring the spudger partly underneath the membrane.
- Lift the membrane off of the first standoff.
- Peel the rest of the membrane off carefully so the membrane doesn’t rip.
Stick the sharp end of the spudger into the corner of the second membrane and bring the spudger partly underneath the membrane.
Lift the membrane off of the first standoff.
Peel the rest of the membrane off carefully so the membrane doesn’t rip.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 2 other contributors
Marcus Jones
Member since: 11/22/2018
1,115 Reputation
6 Guides authored
Badges:
19
+16 more badges
Jacob Sileski - Feb 7, 2021
Reply
I followed your guide for disassembly and did the opposite for reassembly, now all three leds turn on when plugged in but none of the keys respond. Any idea what I should do?
Marcus Jones - Feb 28, 2021
Make sure that the rubber membrane is making contact with the pads on the plastic sheets. If they are, make sure the connector is fully plugged in. If it is, make sure the keyboard is plugged into the right USB port.