Difficulty

Difficult

Steps

6

Time Required

                          10 - 20 minutes            

Sections

1

  • Reset Button
  • 6 steps

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackLogitech Harmony Smart Control

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Soldering Guide

What you need

Step 1

              Reset Button               
  • Using a plastic opening tool, lift up the rubber pad.
  • From the bottom of the device, with your fingers, pull back the rubber pad. This will expose the screw holes.
  • On the bottom of the hub, repeat the step above for the second rubber pad.

Using a plastic opening tool, lift up the rubber pad.

From the bottom of the device, with your fingers, pull back the rubber pad. This will expose the screw holes.

On the bottom of the hub, repeat the step above for the second rubber pad.

1024

Step 2

  • With the PH00 bit, remove the four 6mm Phillips screws.

With the PH00 bit, remove the four 6mm Phillips screws.

Step 3

  • With the plastic opening tool, separate the pieces of plastic from each other

With the plastic opening tool, separate the pieces of plastic from each other

Step 4

  • With the PH00 bit, remove the three 4mm Phillips screws.

With the PH00 bit, remove the three 4mm Phillips screws.

Step 5

  • From the yellow corner, pry the circuit board from the housing..

From the yellow corner, pry the circuit board from the housing..

Step 6

  • Locate the defective reset button.
  • Turn the board around to expose the reset solder.
  • Using soldering iron, remove solder and reset button. Replace reset button and solder.

Locate the defective reset button.

Turn the board around to expose the reset solder.

Using soldering iron, remove solder and reset button. Replace reset button and solder.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 5 other contributors 

                    Zachary Robinson                     

Member since: 09/17/2015

126 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges                           

Team

                       IUPUI, Team 3-2, Harley Fall 2015                        

                                                  Member of IUPUI, Team 3-2, Harley Fall 2015 



                    IUPUI-HARLEY-F15S3G2                     


                                            4 Members                     


                                            5 Guides authored