Logitech Harmony Smart Control Hub Light Bulb Replacement Repair Guide

Difficulty

Difficult

Steps

6

Time Required

                          10 - 20 minutes            

Sections

1

• Light Bulb
• 6 steps

Flags

0

• BackLogitech Harmony Smart Control

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

This repair requires soldering. View the soldering guide at:

Soldering Guide

What you need

Step 1

              Light Bulb               

• Use a spudger to lift up one of the rubber pads on the bottom of the hub.
• Pull back the rubber pad and remove it. This will expose the screws on the bottom of the device.
• Repeat for the second rubber pad.

Use a spudger to lift up one of the rubber pads on the bottom of the hub.

Pull back the rubber pad and remove it. This will expose the screws on the bottom of the device.

Repeat for the second rubber pad.

1024

Step 2

• Use a PH00 screwdriver bit to remove the four 6mm Phillips screws on the bottom of the device.

Use a PH00 screwdriver bit to remove the four 6mm Phillips screws on the bottom of the device.

Step 3

• Use a spudger to separate the top and bottom pieces of the device.

Use a spudger to separate the top and bottom pieces of the device.

Step 4

• Use the PH00 screwdriver bit to unscrew the three 4mm Phillips screws on the control board.

Use the PH00 screwdriver bit to unscrew the three 4mm Phillips screws on the control board.

Step 5

• Place the end of the opening tool under the yellow corner of the circuit board as shown.
• Gently push upward to pry the board from its housing.

Place the end of the opening tool under the yellow corner of the circuit board as shown.

Gently push upward to pry the board from its housing.

Step 6

• Determine which of the five bulbs are defective.
• Turn the board over to expose the bulb solder.
• Using a soldering iron, remove the solder and bulb. Replace with a new bulb and re-solder.

Determine which of the five bulbs are defective.

Turn the board over to expose the bulb solder.

Using a soldering iron, remove the solder and bulb. Replace with a new bulb and re-solder.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.                                             

Author

                                      with 7 other contributors 

                    Josh Hendricks                     

Member since: 09/17/2015

464 Reputation

                                      4 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges                           

Team

                       IUPUI, Team 3-2, Harley Fall 2015                        

                                                  Member of IUPUI, Team 3-2, Harley Fall 2015 



                    IUPUI-HARLEY-F15S3G2                     


                                            4 Members                     


                                            5 Guides authored