Difficulty
Difficult
Steps
6
Time Required
10 - 20 minutes
Sections
1
- Charging Port
- 6 steps
Flags
0
BackLogitech Harmony Smart Control
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Soldering Guide
What you need
Step 1
Charging Port
- Use the plastic opening tool to lift up the rubber pad.
- With your fingers, pull back the rubber pad. This will expose the screw holes on the bottom of the device.
- Repeat the step above for the second rubber pad on the bottom of the hub.
Use the plastic opening tool to lift up the rubber pad.
With your fingers, pull back the rubber pad. This will expose the screw holes on the bottom of the device.
Repeat the step above for the second rubber pad on the bottom of the hub.
1024
Step 2
- Using the PH00 bit, remove the four 6mm Phillips screws
Using the PH00 bit, remove the four 6mm Phillips screws
Step 3
- Use the plastic opening tool to pry open and separate the pieces of plastic from each other.
Use the plastic opening tool to pry open and separate the pieces of plastic from each other.
Step 4
- Using the PH00 bit, remove the three 4mm Phillips screws.
Using the PH00 bit, remove the three 4mm Phillips screws.
Step 5
- Starting at the yellow corner, use a plastic opening tool to pry the circuit board from the housing.
Starting at the yellow corner, use a plastic opening tool to pry the circuit board from the housing.
Step 6
- Locate the defective charging port.
- Turn the circuit board over to expose the charging solder.
- Using a soldering iron, remove the solder and the charging port. Install a new charging port and solder.
Locate the defective charging port.
Turn the circuit board over to expose the charging solder.
Using a soldering iron, remove the solder and the charging port. Install a new charging port and solder.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 4 other contributors
Josh Hendricks
Member since: 09/17/2015
464 Reputation
4 Guides authored
Badges:
7
+4 more badges
Team
IUPUI, Team 3-2, Harley Fall 2015
Member of IUPUI, Team 3-2, Harley Fall 2015
IUPUI-HARLEY-F15S3G2
4 Members
5 Guides authored