Difficulty
Easy
Steps
3
Time Required
3 minutes
Sections
1
- Batteries
- 3 steps
Flags
Better Introduction
Improve this guide by completing or revising its introduction.
BackLogitech Harmony 300
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Step 1
Identifying the Battery Housing
- On the back bottom of the controller, a housing holds the batteries that are used to power the controller.
On the back bottom of the controller, a housing holds the batteries that are used to power the controller.
1024
Step 2
Removing the Battery Cap
- Place a finger on the top of the cap on the indent. While holding the controller with the other hand, press firmly towards the bottom of the controller to loosen the cap.
- Once the cap is loosen, simply lift the cap out to reveal the batteries.
Place a finger on the top of the cap on the indent. While holding the controller with the other hand, press firmly towards the bottom of the controller to loosen the cap.
Once the cap is loosen, simply lift the cap out to reveal the batteries.
Step 3
The Batteries
- Carefully pull the black tap to remove the batteries from the battery housing. When inserting new batteries, be aware of the correct orientation.
Carefully pull the black tap to remove the batteries from the battery housing. When inserting new batteries, be aware of the correct orientation.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 1 other contributor
Andres Rodriguez
Member since: 10/09/2014
137 Reputation
1 Guide authored
Badges:
5
+2 more badges
Team
USF Tampa, Team 1-29, Donnelly Fall 2014
Member of USF Tampa, Team 1-29, Donnelly Fall 2014
USFT-DONNELLY-F14S1G29
1 Member
1 Guide authored
peter.mac83 - Apr 12, 2017
Reply
i bought Harmony 350, and it’s imposibble to open this cover, I tried to open this cover for few hours wihout luck, my fingers hurt. Return this crap to shop, I have also Harmony 700 which in it cover open easy.
Errol - Nov 26, 2017
Reply
This instruction is USELESS the catch is too strong! Note all the other questions about the enclosure.
Pascal jade - May 17, 2018
Reply
it’s impossible !!!
Barry Boehm - Aug 14, 2018
Reply
Dave Davy - Aug 27, 2021
Reply
pefI too found the battery cover impossible to remove “by hand”. I used the clear plastic package as a cradle for the device,
then used a flat-blade screwdriver applied to the indent where you are meant to push by hand, and pushed hard at about
about a 45° angle. Finally got it open! I filed off a bit of the hook on the cover latch so hopfully it will be easier next time.