Difficulty
Easy
Steps
4
Time Required
5 - 7 minutes
Sections
1
- Power Cord
- 4 steps
Flags
Markup Mishap
This guide needs better markups. Help out by correcting or making some markup annotations.
BackLogitech G910
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Power Cord
- Turn over the keyboard and remove the three screws using a Phillips #0 screwdriver.
Turn over the keyboard and remove the three screws using a Phillips #0 screwdriver.
1024
Step 2
- Remove the USB from the keyboard.
Remove the USB from the keyboard.
Step 3
- Make sure the cord tab is not broken.
Make sure the cord tab is not broken.
Step 4
- If the cord tab is not broken, close it back.
If the cord tab is not broken, close it back.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Ahmed Al Hasan
Member since: 01/18/2018
127 Reputation
1 Guide authored
Badges:
5
+2 more badges
Team
Eastern Washington University, Team S2-G2, Munoz Winter 2018
Member of Eastern Washington University, Team S2-G2, Munoz Winter 2018
EWU-MUNOZ-W18S2G2
5 Members
10 Guides authored
pittetflavia - Dec 15, 2019
Reply
Hello,
Where can I find a replacement USB cord ?
My board works fine but sometimes disconnects before the power cable is really used. I just want to change that cable