Difficulty
Moderate
Steps
9
Time Required
20 minutes
Sections
1
- Cable
- 9 steps
Flags
0
BackLogitech Mouse
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Cable
- Use a hairdryer to heat three mouse feet briefly.
- Each mouse foot should take 7-8 seconds to heat up.
Use a hairdryer to heat three mouse feet briefly.
Each mouse foot should take 7-8 seconds to heat up.
1024
Step 2
- Remove the mouse feet gently.
- Avoid bending the mouse feet.
Remove the mouse feet gently.
Avoid bending the mouse feet.
Step 3
- Use a screwdriver to remove the four 12.5 mm screws.
Use a screwdriver to remove the four 12.5 mm screws.
Step 4
- Use a spudger to pry open the bottom case.
- A screwdriver is shown in the photo but screwdrivers shouldn’t be used for prying. They might accidentally damage internal components with a slip.
Use a spudger to pry open the bottom case.
A screwdriver is shown in the photo but screwdrivers shouldn’t be used for prying. They might accidentally damage internal components with a slip.
Step 5
- Raise the tabs to disconnect the ribbon.
Raise the tabs to disconnect the ribbon.
Step 6
- Pull out the pin and remove the scroll wheel assembly.
- Take out the two springs under the scroll wheel assembly.
- Be careful when lifting the scroll wheel assembly. Do not lose the two specified springs.
Pull out the pin and remove the scroll wheel assembly.
Take out the two springs under the scroll wheel assembly.
Be careful when lifting the scroll wheel assembly. Do not lose the two specified springs.
Step 7
- Unscrew five 12.5mm screws from the motherboard.
Unscrew five 12.5mm screws from the motherboard.
Step 8
- Open the tabs lock on each side so you can disconnect the ribbon.
- Disconnect the PCB from the mouse cable.
Open the tabs lock on each side so you can disconnect the ribbon.
Disconnect the PCB from the mouse cable.
Step 9
- Pull out the plastic piece.
- Remove the mouse cable.
Pull out the plastic piece.
Remove the mouse cable.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Sen
Member since: 09/19/2021
169 Reputation
1 Guide authored
Badges:
2
Team
York University, Team E-13, Melo-Thaiss Fall 2021
Member of York University, Team E-13, Melo-Thaiss Fall 2021
YORK-MELO-THAISS-F21SEG13
1 Member
2 Guides authored
