Logitech Extreme 3D Pro Top Button Circuit Board Replacement Repair Guide

Difficulty

Easy

Steps

6

Time Required

                          5 - 10 minutes            

Sections

2

• Disassembly of the handle
• 3 steps
• Top button circuit board
• 3 steps

Flags

0

• BackLogitech Extreme 3D Pro

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Disassembly of the handle               

• Remove these three Phillips #1 screws:
• Two 10mm screws.
• One 7mm screw.

Remove these three Phillips #1 screws:

Two 10mm screws.

One 7mm screw.

1024

Step 2

• Using your fingers, lower the rubber boot to reveal two screws underneath the joystick.
• Remove the two 10mm Phillips #1 screws.

Using your fingers, lower the rubber boot to reveal two screws underneath the joystick.

Remove the two 10mm Phillips #1 screws.

Step 3

• Pull apart the joystick chassis by hand.
• Release this clip located underneath the hand rest
• The circuit board will be loose and may fall down.

Pull apart the joystick chassis by hand.

Release this clip located underneath the hand rest

The circuit board will be loose and may fall down.

Step 4

              Top button circuit board               

• Remove the three 7mm Phillips #1 screws from the button board.
• Remove the button board from the plastic top.
• When taken apart the plastic buttons can fall out.

Remove the three 7mm Phillips #1 screws from the button board.

Remove the button board from the plastic top.

When taken apart the plastic buttons can fall out.

Step 5

• Disconnect the cable from the button board.

Disconnect the cable from the button board.

Step 6

• Disconnect the smaller cable from the button board.

Disconnect the smaller cable from the button board.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.                                             

Author

                                      with 1 other contributor 

                    Emanuel Canela                     

Member since: 01/25/2018

1,097 Reputation

                                      7 Guides authored                  



                       Badges:
                       14







                                                        +11 more badges                           

Team

                       USF Tampa, Team S7-G1, Passmore Spring 2018                        

                                                  Member of USF Tampa, Team S7-G1, Passmore Spring 2018 



                    USFT-PASSMORE-S18S7G1                     


                                            4 Members                     


                                            7 Guides authored