Logitech Extreme 3D Pro Joystick Trigger Replacement Repair Guide

Difficulty

Easy

Steps

4

Time Required

                          1 - 5 minutes            

Sections

2

• Disassembly of the handle
• 3 steps
• Joystick Trigger
• 1 step

Flags

0

• BackLogitech Extreme 3D Pro

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Disassembly of the handle               

• Remove these three Phillips #1 screws:
• Two 10mm screws.
• One 7mm screw.

Remove these three Phillips #1 screws:

Two 10mm screws.

One 7mm screw.

1024

Step 2

• Using your fingers, lower the rubber boot to reveal two screws underneath the joystick.
• Remove the two 10mm Phillips #1 screws.

Using your fingers, lower the rubber boot to reveal two screws underneath the joystick.

Remove the two 10mm Phillips #1 screws.

Step 3

• Pull apart the joystick chassis by hand.
• Release this clip located underneath the hand rest
• The circuit board will be loose and may fall down.

Pull apart the joystick chassis by hand.

Release this clip located underneath the hand rest

The circuit board will be loose and may fall down.

Step 4

              Joystick Trigger               

• Remove the plastic trigger from the joystick.

Remove the plastic trigger from the joystick.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Emanuel Canela                     

Member since: 01/25/2018

1,097 Reputation

                                      7 Guides authored                  



                       Badges:
                       14







                                                        +11 more badges                           

Team

                       USF Tampa, Team S7-G1, Passmore Spring 2018                        

                                                  Member of USF Tampa, Team S7-G1, Passmore Spring 2018 



                    USFT-PASSMORE-S18S7G1                     


                                            4 Members                     


                                            7 Guides authored