Logitech Extreme 3D Pro Disassembly Of The Base Repair Guide

Difficulty

Very easy

Steps

Time Required

                          1 - 5 minutes

Sections

Disassembly of the handle
3 steps
Disassembly of the base
2 steps

Flags

BackLogitech Extreme 3D Pro
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Disassembly of the handle

Remove these three Phillips #1 screws:
Two 10mm screws.
One 7mm screw.

Remove these three Phillips #1 screws:

Two 10mm screws.

One 7mm screw.

1024

Step 2

Using your fingers, lower the rubber boot to reveal two screws underneath the joystick.
Remove the two 10mm Phillips #1 screws.

Using your fingers, lower the rubber boot to reveal two screws underneath the joystick.

Remove the two 10mm Phillips #1 screws.

Step 3

Pull apart the joystick chassis by hand.
Release this clip located underneath the hand rest
The circuit board will be loose and may fall down.

Pull apart the joystick chassis by hand.

Release this clip located underneath the hand rest

The circuit board will be loose and may fall down.

Step 4

              Disassembly of the base

Remove the eight 10mm Phillips #1 screws from the bottom.

Remove the eight 10mm Phillips #1 screws from the bottom.

Step 5

Flip the joystick upright.
Lift up the sliver base cover and feed the loose circuit board through.
Careful with the wires still attached to the silver base cover from the bottom of the joystick.

Flip the joystick upright.

Lift up the sliver base cover and feed the loose circuit board through.

Careful with the wires still attached to the silver base cover from the bottom of the joystick.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 1 other contributor

                    Emanuel Canela

Member since: 01/25/2018

1,097 Reputation

                                      7 Guides authored                  



                       Badges:
                       14







                                                        +11 more badges

Team

                       USF Tampa, Team S7-G1, Passmore Spring 2018                        

                                                  Member of USF Tampa, Team S7-G1, Passmore Spring 2018 



                    USFT-PASSMORE-S18S7G1                     


                                            4 Members                     


                                            7 Guides authored

Jesse James - Feb 23, 2022

And you didn’t even finish the repair. Thanks for nothing. :(

Introduction#

What you need#

Team#

Introduction

What you need

Team