Little Wonder 4 Hp Honda Pro Edger 62320001 Rev B V Belt Replacement Repair Guide

Difficulty

Moderate

Steps

7

Time Required

                          10 - 30 minutes            

Sections

1

• V Belt
• 7 steps

Flags

0

• BackLittle Wonder 4 HP Honda Pro Edger 6232-00-01 - Rev B

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Raise the blade               

• Before you begin, make sure the edger is switched off and the red throttle adjuster is in the disengaged position. Disconnect the spark plug.
• Move the blade adjusting lever down into the raised position.

Before you begin, make sure the edger is switched off and the red throttle adjuster is in the disengaged position. Disconnect the spark plug.

Move the blade adjusting lever down into the raised position.

1024

Step 2

              De-tension the belts               

• Lift the belt slackener lever to take tensions off the belts.
• Secure it in the slackened position.

Lift the belt slackener lever to take tensions off the belts.

Secure it in the slackened position.

Step 3

              Remove the belt guard bolts               

• Use a 3/8 inch socket and ratchet to remove the two bolts securing the belt guard.

Use a 3/8 inch socket and ratchet to remove the two bolts securing the belt guard.

Step 4

              Slide the belt guard out of the way               

• Slide the belt guard forward and away from the belt pulley.
• Slide the guard to the side, away from the wheels to expose the belts.

Slide the belt guard forward and away from the belt pulley.

Slide the guard to the side, away from the wheels to expose the belts.

Step 5

              Remove the belts               

• Slide the inner belt toward the wheel and off of the pulley.

Slide the inner belt toward the wheel and off of the pulley.

Step 6

• Slide the outer belt across the pulley, toward the wheel, and off of the pulley.

Slide the outer belt across the pulley, toward the wheel, and off of the pulley.

Step 7

• Slide both belts away from the engine and off of the pulleys.
• Remove both belts.

Slide both belts away from the engine and off of the pulleys.

Remove both belts.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                    Adam O'Camb                     

Member since: 04/11/2015

173,479 Reputation

                                      418 Guides authored                  



                       Badges:
                       39







                                                        +36 more badges