Difficulty
Moderate
Steps
3
Time Required
2 - 5 minutes
Sections
1
- Blade
- 3 steps
Flags
0
BackLittle Wonder 4 HP Honda Pro Edger 6232-00-01 - Rev B
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Remove the blade nut
- Before you begin, make sure the edger is switched off and the red throttle adjuster is in the disengaged position. Disconnect the spark plug.
- Use a 3/4 inch socket and ratchet to remove the nut securing the blade.
- Brace the left side of the blade against the ground in order to loosen the nut. Brace the right side of the blade against the ground for tightening.
Before you begin, make sure the edger is switched off and the red throttle adjuster is in the disengaged position. Disconnect the spark plug.
Use a 3/4 inch socket and ratchet to remove the nut securing the blade.
Brace the left side of the blade against the ground in order to loosen the nut. Brace the right side of the blade against the ground for tightening.
1024
Step 2
Remove the blade washer
- Remove the blade washer.
Remove the blade washer.
Step 3
Remove the blade
- Remove the blade.
Remove the blade.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
Adam O'Camb
Member since: 04/11/2015
173,479 Reputation
418 Guides authored
Badges:
39
+36 more badges