Difficulty

Moderate

Steps

8

Time Required

                          10 - 15 minutes

Sections

3

  • Chassis
  • 6 steps
  • Disc Tray
  • 1 step
  • Disc Tray Belt
  • 1 step

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackLite-On iHAS324

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Chassis
  • Insert a paper clip into a small hole on the right side of the faceplate bellow the disc tray.
  • There may be resistance, do not be afraid to use force.
  • The tray should then pop open.
  • Pull out the tray so that it is fully extended.

Insert a paper clip into a small hole on the right side of the faceplate bellow the disc tray.

There may be resistance, do not be afraid to use force.

The tray should then pop open.

Pull out the tray so that it is fully extended.

1024

Step 2

  • Use a plastic opening tool to push the three tabs located on the right, left, and bottom side of the outer chassis to loosen the faceplate off.

Use a plastic opening tool to push the three tabs located on the right, left, and bottom side of the outer chassis to loosen the faceplate off.

Step 3

  • Pull the faceplate off the chassis.
  • Do NOT pull the faceplate all the way off the disc tray, because doing so can cause damage to the faceplate.
  • There may be resistance, do not be afraid to use force.

Pull the faceplate off the chassis.

Do NOT pull the faceplate all the way off the disc tray, because doing so can cause damage to the faceplate.

Step 4

  • Using the Phillips Head #2 screwdriver, unscrew the two 8.5 mm screws located on the bottom back of the chassis.

Using the Phillips Head #2 screwdriver, unscrew the two 8.5 mm screws located on the bottom back of the chassis.

Step 5

  • Remove the bottom plate by lifting it off the device.

Remove the bottom plate by lifting it off the device.

Step 6

  • Turn the device over.
  • Remove the top plate by pulling the sides and lifting the plate off.

Turn the device over.

Remove the top plate by pulling the sides and lifting the plate off.

Step 7

              Disc Tray
  • Push the left tab in and slide the tray out on the left side.
  • Pull the gray plastic casing on the right side away from the tray.
  • Slide the right side of the tray out.

Push the left tab in and slide the tray out on the left side.

Pull the gray plastic casing on the right side away from the tray.

Slide the right side of the tray out.

Step 8

              Disc Tray Belt
  • Take tweezers and remove the black tray belt from the gears carefully.

Take tweezers and remove the black tray belt from the gears carefully.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 1 other contributor 


                    Kayla Culpepper

Member since: 03/22/2015

675 Reputation

                                      5 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       Baylor, Team 5-9, Williams Spring 2015                        

                                                  Member of Baylor, Team 5-9, Williams Spring 2015 



                    BU-WILLIAMS-S15S5G9                     


                                            3 Members                     


                                            5 Guides authored