Difficulty

Moderate

Steps

7

Time Required

Suggest a time??

Sections

3

  • Front Case
  • 4 steps
  • Motherboard
  • 2 steps
  • Rear Case
  • 1 step

Flags

0

  • BackLinksys WRT54GS v2

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Front Case
  • Turn the router over so that all four of its feet are facing upwards.

Turn the router over so that all four of its feet are facing upwards.

1024

Step 2

  • Remove the rubber inserts inside the the two purple feet located on the router’s front case.
  • This may be a challenge, so try the following two methods:
  • Use a plastic opening tool. Insert the flat end of the tool into the seam and slowly pry the rubber feet out.
  • Use a metal spudger. Insert the point of the metal spudger directly into the hole of the rubber feet and pry the insert out.

Remove the rubber inserts inside the the two purple feet located on the router’s front case.

This may be a challenge, so try the following two methods:

Use a plastic opening tool. Insert the flat end of the tool into the seam and slowly pry the rubber feet out.

Use a metal spudger. Insert the point of the metal spudger directly into the hole of the rubber feet and pry the insert out.

Step 3

  • Use a Phillips #2 Screwdriver to remove the two 5.8 mm screws holding the front case to the motherboard.

Use a Phillips #2 Screwdriver to remove the two 5.8 mm screws holding the front case to the motherboard.

Step 4

  • Squeeze the sides of the router’s backcase inward and pull off the purple front case. It is helpful to have a second person assist you for this step.

Squeeze the sides of the router’s backcase inward and pull off the purple front case. It is helpful to have a second person assist you for this step.

Step 5

              Motherboard
  • Slide the board unit out and up.

Slide the board unit out and up.

Step 6

  • Flip the circuit board over and use a Phillips #2 Screwdriver to remove the 6.9mm screw holding the board to the back case.
  • Slide the back cover out and away from the circuit board.

Flip the circuit board over and use a Phillips #2 Screwdriver to remove the 6.9mm screw holding the board to the back case.

Slide the back cover out and away from the circuit board.

Step 7

              Rear Case
  • Removing the router’s rear case is the same as removing the motherboard, since the two parts are attached to each other.
  • Once you complete this step, your router will be completely disassembled.

Removing the router’s rear case is the same as removing the motherboard, since the two parts are attached to each other.

Once you complete this step, your router will be completely disassembled.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Allian Roman

Member since: 10/12/2011

276 Reputation

                                      5 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Cal Poly, Team 3-4, Regan Fall 2011                        

                                                  Member of Cal Poly, Team 3-4, Regan Fall 2011 



                    CPSU-REGAN-F11S3G4                     


                                            4 Members                     


                                            6 Guides authored