Featured
Featured Guide
Difficulty
Moderate
Steps
6
Time Required
Suggest a time??
Sections
2
- Front Case
- 4 steps
- Motherboard
- 2 steps
Flags
1
Featured Guide
This guide has been found to be exceptionally cool by the iFixit staff.
BackLinksys WRT54GS v2
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Front Case
- Turn the router over so that all four of its feet are facing upwards.
Turn the router over so that all four of its feet are facing upwards.
1024
Step 2
- Remove the rubber inserts inside the the two purple feet located on the router’s front case.
- This may be a challenge, so try the following two methods:
- Use a plastic opening tool. Insert the flat end of the tool into the seam and slowly pry the rubber feet out.
- Use a metal spudger. Insert the point of the metal spudger directly into the hole of the rubber feet and pry the insert out.
Remove the rubber inserts inside the the two purple feet located on the router’s front case.
This may be a challenge, so try the following two methods:
Use a plastic opening tool. Insert the flat end of the tool into the seam and slowly pry the rubber feet out.
Use a metal spudger. Insert the point of the metal spudger directly into the hole of the rubber feet and pry the insert out.
Step 3
- Use a Phillips #2 Screwdriver to remove the two 5.8 mm screws holding the front case to the motherboard.
Use a Phillips #2 Screwdriver to remove the two 5.8 mm screws holding the front case to the motherboard.
Step 4
- Squeeze the sides of the router’s backcase inward and pull off the purple front case. It is helpful to have a second person assist you for this step.
Squeeze the sides of the router’s backcase inward and pull off the purple front case. It is helpful to have a second person assist you for this step.
Step 5
Motherboard
- Slide the board unit out and up.
Slide the board unit out and up.
Step 6
- Flip the circuit board over and use a Phillips #2 Screwdriver to remove the 6.9mm screw holding the board to the back case.
- Slide the back cover out and away from the circuit board.
Flip the circuit board over and use a Phillips #2 Screwdriver to remove the 6.9mm screw holding the board to the back case.
Slide the back cover out and away from the circuit board.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 4 other contributors
Allian Roman
Member since: 10/12/2011
276 Reputation
5 Guides authored
Badges:
7
+4 more badges
Team
Cal Poly, Team 3-4, Regan Fall 2011
Member of Cal Poly, Team 3-4, Regan Fall 2011
CPSU-REGAN-F11S3G4
4 Members
6 Guides authored