Difficulty
Moderate
Steps
6
Time Required
3 hours
Sections
2
- Linksys EA9200 Disassembly
- 5 steps
- USB Port
- 1 step
Flags
0
BackLinksys EA9200
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Linksys EA9200 Disassembly
- Remove the sticker on the bottom.
- Remove the two screws holding the bottom plate in place. Use Phillips screwdriver tip #1 , the screw head-size is 5mm.
Remove the sticker on the bottom.
Remove the two screws holding the bottom plate in place. Use Phillips screwdriver tip #1 , the screw head-size is 5mm.
1024
Step 2
- Remove the back sticker that has all the labels.
- There are two screws to remove. They are 6mm in diameter, use phillips screw tip #1.
Remove the back sticker that has all the labels.
There are two screws to remove. They are 6mm in diameter, use phillips screw tip #1.
Step 3
- Depress the 12 clips along the edge into the router. Use the nylon spudger as using a metal object could cause damage.
Depress the 12 clips along the edge into the router. Use the nylon spudger as using a metal object could cause damage.
Step 4
- Once you have one side open, keep a spudger wedged between both sides. This will help keep it open in case it tries to snap back together.
- These clips are tough and may need some additional force.
Once you have one side open, keep a spudger wedged between both sides. This will help keep it open in case it tries to snap back together.
These clips are tough and may need some additional force.
Step 5
- Lift the board and pull down, away from the antennas.
Lift the board and pull down, away from the antennas.
Step 6
USB Port
- Desolder the 6 pin points fully.
- How To Solder and Desolder Connections is iFixit’s official guide on how to use a soldering iron.
- You will need a soldering iron that is capable of reaching temperatures greater than 300 degrees Fahrenheit.
- Temperature of the component will be very hot when desoldered, take precaution when handling.
Desolder the 6 pin points fully.
How To Solder and Desolder Connections is iFixit’s official guide on how to use a soldering iron.
You will need a soldering iron that is capable of reaching temperatures greater than 300 degrees Fahrenheit.
Temperature of the component will be very hot when desoldered, take precaution when handling.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Shane Davis
Member since: 10/05/2016
374 Reputation
3 Guides authored
Badges:
8
+5 more badges
Team
USF Tampa, Team 9-1, Lacy Fall 2016
Member of USF Tampa, Team 9-1, Lacy Fall 2016
USFT-LACY-F16S9G1
4 Members
5 Guides authored