Difficulty

Moderate

Steps

5

Time Required

                          1 hour

Sections

1

  • Linksys EA9200 Disassembly
  • 5 steps

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackLinksys EA9200

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Linksys EA9200 Disassembly
  • Remove the sticker on the bottom.
  • Remove the two screws holding the bottom plate in place. Use Phillips screwdriver tip #1 , the screw head-size is 5mm.

Remove the sticker on the bottom.

Remove the two screws holding the bottom plate in place. Use Phillips screwdriver tip #1 , the screw head-size is 5mm.

1024

Step 2

  • Remove the back sticker that has all the labels.
  • There are two screws to remove. They are 6mm in diameter, use phillips screw tip #1.

Remove the back sticker that has all the labels.

There are two screws to remove. They are 6mm in diameter, use phillips screw tip #1.

Step 3

  • Depress the 12 clips along the edge into the router. Use the nylon spudger as using a metal object could cause damage.

Depress the 12 clips along the edge into the router. Use the nylon spudger as using a metal object could cause damage.

Step 4

  • Once you have one side open, keep a spudger wedged between both sides. This will help keep it open in case it tries to snap back together.
  • These clips are tough and may need some additional force.

Once you have one side open, keep a spudger wedged between both sides. This will help keep it open in case it tries to snap back together.

These clips are tough and may need some additional force.

Step 5

  • Lift the board and pull down, away from the antennas.

Lift the board and pull down, away from the antennas.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 5 other contributors 


                    Henry Cates

Member since: 10/01/2016

219 Reputation

                                      1 Guide authored                  



                       Badges:
                       14







                                                        +11 more badges

Team

                       USF Tampa, Team 9-1, Lacy Fall 2016                        

                                                  Member of USF Tampa, Team 9-1, Lacy Fall 2016 



                    USFT-LACY-F16S9G1                     


                                            4 Members                     


                                            5 Guides authored

Josiah Freeman - Aug 8, 2020

Reply

Thank you for making this guide, Henry! I used this to help disassemble an EA7300. EA7300 has just 4 screws, all under the rubber pads on the bottom. Pull the pads off (they’re glued on and pulling them off does not destroy them) and set them aside with the adhesive facing up to keep the adhesive clean for sticking back on. At least for the EA7300, there are no clips in the corners. Pry a front corner enough to slide in any plastic card you don’t mind it gets damaged and bent. Push it in as far as possible…you should feel it hit stopping points. Slide the card through the crack to the side towards the stop, which is a clip. … (finishes in next post)