Difficulty
Moderate
Steps
3
Time Required
Suggest a time??
Sections
1
- Linear Rail V2/V3 Endstop Install
- 3 steps
Flags
In Progress
This guide is a work in progress. Reload periodically to see the latest changes!
Markup Mishap
This guide needs better markups. Help out by correcting or making some markup annotations.
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackCreality CR-10 V2
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Linear Rail V2/V3 Endstop Install
- M3 Sliding T-Nut
- Slide in the M3 T-Nut toward the middle of the printer
- M3X12 BHCS & M3 FLAT WASHERS
- M3x10 FHCS
- Adjustable Endstop Mount A
- Adjustable Endstop Mount B
- Tighten the M3 screw into the T-Nut
M3 Sliding T-Nut
Slide in the M3 T-Nut toward the middle of the printer
M3X12 BHCS & M3 FLAT WASHERS
M3x10 FHCS
Adjustable Endstop Mount A
Adjustable Endstop Mount B
Tighten the M3 screw into the T-Nut
1024
Step 2
Endstop install
- Adjust endstop mount until it is square with the Linear rail
- Remove stock endstop board form Creality mount and Reuse the stock screws to mount the endstop as shown
Adjust endstop mount until it is square with the Linear rail
Remove stock endstop board form Creality mount and Reuse the stock screws to mount the endstop as shown
Step 3
Setting endstop position
- Use M3x12 BHCS to adjust the endstop position, so the nozzle tip is even with the front edge of the bed when the end stop is triggered
- Check the clearance between the motor and the linear adaptor. When the bed is all the way back against the endstop. There should be a 1-2 mm gap when the endstop is triggered.
Use M3x12 BHCS to adjust the endstop position, so the nozzle tip is even with the front edge of the bed when the end stop is triggered
Check the clearance between the motor and the linear adaptor. When the bed is all the way back against the endstop. There should be a 1-2 mm gap when the endstop is triggered.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
AJ Pereira
Member since: 05/29/2020
2,049 Reputation
14 Guides authored
Badges:
9
+6 more badges
Team
Tiny Machines 3D
Member of Tiny Machines 3D
Community
5 Members
31 Guides authored