Difficulty
Difficult
Steps
2
Time Required
Suggest a time??
Sections
1
- Strap
- 2 steps
Flags
Needs More Images
A few more images would make this guide’s procedures crystal clear.
BackLightahead DV328
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
There is only one caution that should be noted when working on this device: opening the cover. This should be done with caution as the motherboard is directly underneath it. If it is lifted up too much or with excessive force, the piece will snap in half.
What you need
Step 1
Strap
- To access the area underneath the camcorder, remove the two pieces covering the screws with a plastic spudger.
- Remove the two Phillips #2 screws.
- Gently pull up the cover.
To access the area underneath the camcorder, remove the two pieces covering the screws with a plastic spudger.
Remove the two Phillips #2 screws.
Gently pull up the cover.
1024
Step 2
- Pull off the lens.
- Be careful not to pull the cover too far up, otherwise it will snap in half.
- Inside the device the motherboard and a screw will be visible.
- Remove the pictured Philips #0 screw to release the strap.
Pull off the lens.
Be careful not to pull the cover too far up, otherwise it will snap in half.
Inside the device the motherboard and a screw will be visible.
Remove the pictured Philips #0 screw to release the strap.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Alexandra McMurray
Member since: 01/20/2016
355 Reputation
3 Guides authored
Badges:
8
+5 more badges
Team
USF Tampa, Team 10-2, Remmell Spring 2016
Member of USF Tampa, Team 10-2, Remmell Spring 2016
USFT-REMMELL-S16S10G2
3 Members
3 Guides authored