Lifeprint 3X4 5 Battery Replacement Repair Guide

Difficulty

Moderate

Steps

4

Time Required

Suggest a time??

Sections

3

• Top Cover
• 1 step
• Inner Cover
• 1 step
• Battery
• 2 steps

Flags

2

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Missing Details

Some of this guide’s details are missing. Help users by adding tools, difficulty, or time.

• BackLifePrint 3x4.5

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Top Cover               

• Place one hand on the top cover and one hand on the bottom portion of the LifePrint.
• While having the LP logo on the printer facing away from you, push the top cover away from you until it can’t be slid away any further.
• Pull the cover with the LP logo up to separate it from the rest of the printer.

Place one hand on the top cover and one hand on the bottom portion of the LifePrint.

While having the LP logo on the printer facing away from you, push the top cover away from you until it can’t be slid away any further.

Pull the cover with the LP logo up to separate it from the rest of the printer.

1024

Step 2

              Inner Cover               

• Using a Phillips #0 screwdriver, remove the four 15 mm screws connecting both sections of the device.
• Use an opening tool to remove the inner cover from the printer.

Using a Phillips #0 screwdriver, remove the four 15 mm screws connecting both sections of the device.

Use an opening tool to remove the inner cover from the printer.

Step 3

              Battery               

• Remove three 4mm Phillips #0 screws connecting the metal shield covering the battery.
• Slide out the white power connector with two red wires, two black wires, and one yellow wire from the terminal connected to the circuit board.
• Apply pressure gently and slowly from underneath the battery from the plastic.

Remove three 4mm Phillips #0 screws connecting the metal shield covering the battery.

Slide out the white power connector with two red wires, two black wires, and one yellow wire from the terminal connected to the circuit board.

Apply pressure gently and slowly from underneath the battery from the plastic.

Step 4

• Remove the battery from the printer.

Remove the battery from the printer.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Jacqueline Broderick                     

Member since: 11/05/2019

341 Reputation

                                      3 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge                           

Team

                       UMass Dartmouth, Team S1-G2, Barthe Fall 2019                        

                                                  Member of UMass Dartmouth, Team S1-G2, Barthe Fall 2019 



                    UMASSD-BARTHE-F19S1G2                     


                                            3 Members                     


                                            3 Guides authored