Lifeprint 2X3 Motor Feeder Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          20 minutes

Sections

Motor-Feeder
5 steps

Flags

BackLifePrint 2x3
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

Step 1

              Motor-Feeder

Make sure the top of the Lifeprint is facing upwards displaying the Lifeprint logo.
Slide open the top cover and remove the top lid.

Make sure the top of the Lifeprint is facing upwards displaying the Lifeprint logo.

Slide open the top cover and remove the top lid.

1024

Step 2

Remove the six screws on the outer sides of the device with the Phillips #00 screwdriver.
The motor is highlighted in orange.

Remove the six screws on the outer sides of the device with the Phillips #00 screwdriver.

The motor is highlighted in orange.

Step 3

After removing the six screws, gently flip the device over so the bottom cover is facing you.
Remove the bottom cover by using the opening pick.

After removing the six screws, gently flip the device over so the bottom cover is facing you.

Remove the bottom cover by using the opening pick.

Step 4

Remove the four screws using the Phillips #00 screwdriver to access the motor and sensor (highlighted in orange).

Remove the four screws using the Phillips #00 screwdriver to access the motor and sensor (highlighted in orange).

Step 5

Remove the component holding the motor and feeder.
Using a spudger remove the top piece of the component to get to the motor and feeder.
Remove the motor and feeder assembly from the device.

Remove the component holding the motor and feeder.

Using a spudger remove the top piece of the component to get to the motor and feeder.

Remove the motor and feeder assembly from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor

                    Calli Brown

Member since: 09/24/2019

172 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       Embry-Riddle Aeronautical University, Team S15-G6, Lamothe Fall 2019                        

                                                  Member of Embry-Riddle Aeronautical University, Team S15-G6, Lamothe Fall 2019 



                    ERAU-LAMOTHE-F19S15G6                     


                                            4 Members                     


                                            3 Guides authored

Introduction#

Team#

Introduction

Team