Difficulty
Moderate
Steps
7
Time Required
10 minutes
Sections
4
- Battery
- 2 steps
- Screen
- 2 steps
- Motherboard
- 2 steps
- Top Speaker
- 1 step
Flags
1
Better Introduction
Improve this guide by completing or revising its introduction.
BackLG X Style
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Power down the device and make sure that it is turned off.
- Insert the plastic opening tool into the bracket space on the back bottom left of the phone.
- Gently twist tool clockwise until the back case pops open [this will create a small gap].
- Slide the tool along the gap around the entire device.
Power down the device and make sure that it is turned off.
Insert the plastic opening tool into the bracket space on the back bottom left of the phone.
Gently twist tool clockwise until the back case pops open [this will create a small gap].
Slide the tool along the gap around the entire device.
1024
Step 2
- Insert the plastic opening tool into the indent below the battery, and pry up to lift and remove the battery.
Insert the plastic opening tool into the indent below the battery, and pry up to lift and remove the battery.
Step 3
Screen
- With a Phillips #000 screwdriver, remove the twelve 3mm screws.
With a Phillips #000 screwdriver, remove the twelve 3mm screws.
Step 4
- Create a gap with plastic opening tool by applying pressure between glass screen and plastic edge of device.
- Slide prying tool around entire device beginning toward the top.
- Lift off and remove the screen from the device.
Create a gap with plastic opening tool by applying pressure between glass screen and plastic edge of device.
Slide prying tool around entire device beginning toward the top.
Lift off and remove the screen from the device.
Step 5
Motherboard
- Using the plastic opening tool, carefully slide the edge of the tool under the press fit cable connections and lift up to disconnect. Do this for all three ribbon cables.
Using the plastic opening tool, carefully slide the edge of the tool under the press fit cable connections and lift up to disconnect. Do this for all three ribbon cables.
Step 6
- Using the iFixit opening tool, remove the motherboard from the screen by inserting the opening tool under the edge of the motherboard and lifting up.
Using the iFixit opening tool, remove the motherboard from the screen by inserting the opening tool under the edge of the motherboard and lifting up.
Step 7
Top Speaker
- Use the nylon-tip reverse tweezers to remove the front facing speaker.
Use the nylon-tip reverse tweezers to remove the front facing speaker.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Ryan Downing
Member since: 10/03/2019
94 Reputation
1 Guide authored
Badges:
5
+2 more badges
Team
The Citadel Military College of South Carolina, Team S1-G20, Eggleston Fall 2019
Member of The Citadel Military College of South Carolina, Team S1-G20, Eggleston Fall 2019
CMCSC-EGGLESTON-F19S1G20
3 Members
6 Guides authored