Difficulty
Moderate
Steps
6
Time Required
5 - 10 minutes
Sections
2
- Battery
- 2 steps
- Keypad
- 4 steps
Flags
1
Incorrect Tools
Help make this guide better by using the correct tools in images and/or text.
BackLG VX3200
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Press button labeled “Push”. In the photo depicted the button is being depressed by the left finger.
- Pull back panel toward bottom of phone.
Press button labeled “Push”. In the photo depicted the button is being depressed by the left finger.
Pull back panel toward bottom of phone.
1024
Step 2
- From the lip on the top of the battery, lift it out of the phone.
From the lip on the top of the battery, lift it out of the phone.
Step 3
Keypad
- Remove the 4 small screws from the back panel, under the battery, using 00 Phillips-head.
Remove the 4 small screws from the back panel, under the battery, using 00 Phillips-head.
Step 4
- Starting at the top of the phone near the antenna, use a screwdriver or other small tool, maybe even fingernails, to pry the rear panel off.
- There are 4 places where the panel snaps together to the main part of the phone.
- By systematically prying up the edges of the back panel, moving about a quarter of an inch, and prying again, the panel will begin to lift off.
- Don’t be afraid to damage anything, the panel requires a bit of force to detach.
Starting at the top of the phone near the antenna, use a screwdriver or other small tool, maybe even fingernails, to pry the rear panel off.
There are 4 places where the panel snaps together to the main part of the phone.
By systematically prying up the edges of the back panel, moving about a quarter of an inch, and prying again, the panel will begin to lift off.
Don’t be afraid to damage anything, the panel requires a bit of force to detach.
Step 5
- The logic board is only held on with 4 tabs and a data cable in the top right. Simply pry from one side using a screwdriver, popping out the board, before lifting the display data cable.
The logic board is only held on with 4 tabs and a data cable in the top right. Simply pry from one side using a screwdriver, popping out the board, before lifting the display data cable.
Step 6
- Lift the keypad up from beneath the logic board.
- It is not glued or secured in any way, so it should come away easily.
Lift the keypad up from beneath the logic board.
It is not glued or secured in any way, so it should come away easily.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 4 other contributors
Bradley Hutchinson
Member since: 01/19/2010
42 Reputation
5 Guides authored
Badges:
7
+4 more badges
Team
Cal Poly, Team 5-9, Forte Winter 2010
Member of Cal Poly, Team 5-9, Forte Winter 2010
CPSU-FORTE-W10S5G9
5 Members
10 Guides authored