Difficulty
Moderate
Steps
8
Time Required
3 minutes
Sections
4
- Back Panel
- 1 step
- Battery
- 1 step
- Midframe
- 4 steps
- Motherboard
- 2 steps
Flags
0
BackLG Risio
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Panel
- Use a plastic opening tool to seperate the back panel from the device.
- Remove the back panel.
Use a plastic opening tool to seperate the back panel from the device.
Remove the back panel.
1024
Step 2
Battery
- Place your thumb along the bottom of the battery and pry upwards to remove.
Place your thumb along the bottom of the battery and pry upwards to remove.
Step 3
Midframe
- Press down on the SIM eject tab with a fingernail (or iFixit opening tool), and slide the SIM card out.
Press down on the SIM eject tab with a fingernail (or iFixit opening tool), and slide the SIM card out.
Step 4
- Remove the eight Phillips #0 screws from the internal support frame.
Remove the eight Phillips #0 screws from the internal support frame.
Step 5
- Use an opening tool on the marked locations to lift the edges up. There should be a small click when lifting these edges up.
Use an opening tool on the marked locations to lift the edges up. There should be a small click when lifting these edges up.
Step 6
- Using your hand, pick up the midframe to separate it from the phone.
Using your hand, pick up the midframe to separate it from the phone.
Step 7
Motherboard
- Detach the screen connector from the motherboard by putting your thumb underneath it and lifting up.
- The screen connector is the part that has P5 written on it.
Detach the screen connector from the motherboard by putting your thumb underneath it and lifting up.
The screen connector is the part that has P5 written on it.
Step 8
- On the side with the screen connector, pull the two tabs away from the device.
- Use the plastic opening tool to lift the motherboard starting on the bottom right corner and pulling upwards.
On the side with the screen connector, pull the two tabs away from the device.
Use the plastic opening tool to lift the motherboard starting on the bottom right corner and pulling upwards.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Erika Heppner
Member since: 02/21/2018
316 Reputation
4 Guides authored
Badges:
9
+6 more badges
Team
University of North Texas, Team S4-G6, Thompson Spring 2018
Member of University of North Texas, Team S4-G6, Thompson Spring 2018
UNT-THOMPSON-S18S4G6
4 Members
14 Guides authored